How to Build a Garage Door Header?

Answer

When you are building a garage door header the first thing that you want to do is cut the lumber in twelve inch pieces. Lay one of the pieces across two sawhorses. Next, paint the door with a solid layer of wood glue.
Q&A Related to "How to Build a Garage Door Header?"
1. Cut three pieces of 1½-inch-by-11½-inch lumber to the width measurement of the garage door rough opening plus 12 inches. 2. Rip 11-inch-wide strips of ½-inch
http://www.ehow.com/how_5980594_build-garage-door-...
First disengage the springs on each side of the door. Now adjust the height of the door based on the bracket notches. Reattach the springs and test for accuracy.
http://answers.ask.com/Vehicles/Autos/how_to_adjus...
Depending on the snow load. If it's in the gable end [non-bearing] a 3 2x10 would be good. If it's in a bearing wall you woud need a 3 2x12 buildup beam. You can also get a paralam
http://www.webanswers.com/home-garden/garages/what...
Installing a garage door opener requires basic carpentry and electrical skills. While not very difficult, care must be taken to make sure all parts of the garage door opener are aligned
http://www.life123.com/home-garden/home-appliances...
Explore this Topic
The first step in installing a garage door is the act of framing. This is done by adding a header and trim to the door. The header and trim supports the garage ...
How much a manufactured wood beam used for a garage header that measures 12 inches by 20 feet weighs depends on several factors - such as the type of wood that ...
To fit a canopy garage door, you should first measure he garage door header width, inside the door jambs, with the garage door closed and then cut a piece of garage ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com