How Do I Install a Chimney Flue?

Answer

The weight of the flue system must be supported either by a floor support, rafter support or wall support. The first step is to construct a support make sure that the support component takes the weight not the stove. The fixing can be a wall band or wall fixing bracket (to prevent lateral movement) or one of the load bearing supports as above. The flue must be at least 50mm from combustible surfaces.If the stove is on a combustible floor then it must sit on a non-combustible hearth 250mm thick and extending 150mm to the sides and back and 300mm to the front of the stove. If the stove has been shown not raise the hearth temperature to above 100 degrees then the hearth may be only 12mm thick.
Q&A Related to "How Do I Install a Chimney Flue"
1. Take out the chimney damper in your fireplace. Remove the pins holding it in place with needle-nose pliers, and lift the damper out with your hands. 2. Use the measuring tape to
http://www.ehow.com/how_6547385_install-chimney-fl...
By install a chimney flue I gather you mean a liner. The most common liners are flexi-liners made from aluminium (Kopex) and come in various sizes to accomodate various heating appliances
http://answers.yahoo.com/question/index?qid=201307...
In typical home construction, the house and chimney are set on different foundations. Over time, these foundations may move in different directions, causing a gap to form between
http://www.life123.com/home-garden/home-repair/chi...
A flue is a duct, pipe, or chimney for conveying exhaust gases from a fireplace, furnace, water heater, boiler, or generator to the outdoors.
http://www.chacha.com/question/what-is-a-chimney-f...
Explore this Topic
The cost of installation of a new chimney liner will include the price of the new liner, the insulation material needed, and the labor involved in the installation ...
Yes, one can have a Wood Burning Stove without a chimney, but it is advisable to get a chimney with a large enough flue to cope with the output that one needs ...
Dampers are installed in wood-burning stoves, just over the chimney's opening. The dampers, when open, let hot air and smoke escape into the chimney. Dampers should ...
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com