How to Adjust Quadrajet Carb?

Answer

There are about three or four different models. Make sure you know which model you are working with and make the little adjustments required. Adjusting Instructions www.ehow.com
Reference:
2 Additional Answers
If you're going to adjust a quadrajet carb you will need to get the book to show you so cause there are many types of carbs. Just turn the screws til you get the fuel and air mix that you want.
You can adjust a quadrajet carb without too much work. Turn both of the adjustment screws until they barely bottom out. Then turn them the other way one and one half turns. Start the engine and allow it to warm up. Use either a tachometer or a vacuum gauge and turn the screws one at a time. You're looking for the highest reading you can get, no matter which gauge you're using. If you don't have a gauge, you can also adjust based on the sound of the engine. Set the idle to 1,000 rpm and you're done.
Q&A Related to "How to Adjust Quadrajet Carb"
1. Start the engine and allow it to run until the thermostat opens and upper radiator hose becomes hot. Many Quadrajets are computer-controlled, and operating temperature must be
http://www.ehow.com/how_7557958_adjust-idle-screws...
on the base plate of the carb there are 2 screws that usually have slots for a flat screw driver. start your engine and turn the screws in just until the idle changes then back them
http://answers.yahoo.com/question/index?qid=201204...
Adjusting a Quadrajet carburetor requires basic knowledge behind the theory and concept of this carburetor. In a nutshell, Quadrajet carburetors have different barrel sizes for its
http://www.howtodothings.com/automotive/how-to-adj...
You can buy a kit with new jets and metering rods for this purpose. Quadrajets can be a little tricky, so you might want to get a how-to book and read up on the procedure.
http://wiki.answers.com/Q/How_do_you_adjust_the_ai...
Explore this Topic
1. Hook up the tachometer by attaching the black wire to the negative terminal on the battery. Attach the red wire to the positive terminal and the green wire ...
1. Hook up the tachometer by attaching the black wire to the negative terminal on the battery. Attach the red wire to the positive terminal and the green wire ...
To tune a quadrajet carb you will need to rotate the adjustment screws and start your car. Remove the vacuum hose from the carburetor and attach the tachometer ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com