How to Bypass the Pressure Switch in the Seat of a John Deere Mower?

Answer

Under the seat, you should have two wires that are attached to the seat. Cut and strip both wires and tie the both wires together. Try to start the mower, it should start.If it starts use a wire nut and electrical tape on the connection and forget about it.If the mower does not start then cut the wires and insulate them both with electrical tape separatley and the mower should now start.
Q&A Related to "How to Bypass the Pressure Switch in the Seat..."
There is also a deck safety switch that you might want to check. Check and see if the blades and pulleys on your deck are moving freely if you have rope or some thing wrapped around
http://wiki.answers.com/Q/Why_does_your_John_Deere...
1. Turn off the engine and remove the key from the ignition. 2. Tilt up the seat on your mower and allow the engine to cool, if it was recently run. 3. Locate the safety switch on
http://www.ehow.com/how_8753292_disconnect-john-de...
Under the seat there should be two wires attached to the seat. Cut and strip both wires and twist them together and try to start the mower. If it starts, use a wire nut and electrical
http://answers.yahoo.com/question/index?qid=200907...
Disable the Switch Lift the seat of the mower up so you can access the switch that is wired to the bottom. Unplug the switch from the socket that is on the seat. Cut the insulation
http://www.ehow.co.uk/m/how_6058835_bypass-john-de...
Explore this Topic
To bypass the seat safety switch on a John Deere tractor flip the seat up, find the switch (it may be held with a Phillips head screw), pull the switch out, remove ...
1. Turn off the engine and and remove the key form the ignition switch. 2. Set the parking brake and raise the operator's seat. Locate the release valves on the ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com