How to Caulk a Shower Stall?

Answer

To caulk a shower stall, start by removing any old caulk that surrounds the shower stall and use a detergent to wipe the area where you need to caulk. Dry the area completely and then fix the caulk into a caulk gun. Prepare the tub and then place the caulk gun at a 45-degree angle to the surface and run a bed along the length of the seam.
Q&A Related to "How to Caulk a Shower Stall?"
1. Remove any old caulk surrounding the shower stall. Depending on the type of caulk, you may need to use a razor blade or a pair of needle-nose pliers. Be careful not to scratch
http://www.ehow.com/how_5513731_caulk-shower-stall...
If any gaps appear in the caulk bead go back over them with another layer of caulk. Make sure to over lap the gap on both sides to ensure an even seam.
http://plumbing.about.com/od/diypluming/ss/Caulkst...
any silicone tub/tile caulking, this will hold up against the water abuse and prevent mold, mildew - abit more but woth the investment - Source(s) master plumber.
http://answers.yahoo.com/question/index?qid=201004...
1. Locate the screws on either side of the grid strainer above the drain. Ad. 2. Unscrew the grid drainer. 3. Inspect the grid drainer to see if it is clean. If it is clean, you can
http://www.wikihow.com/Caulk-a-Shower-Drain
1 Additional Answer
Ask.com Answer for: how to caulk a shower stall
How to Caulk a Shower Stall
Whether you're replacing old caulk or have installed a new shower stall, you need to caulk the seams. Done correctly, the caulk gives the shower a completed look while providing a watertight seal along the seams. If you caulk a shower stall incorrectly,... More »
Difficulty: Easy
Source: www.ehow.com
Explore this Topic
To replace a shower stall, first close the water valve and take off the shower head. Then cut through the silicone caulk using a blade then tow the unit from the ...
To remove silicone caulk from a shower you first use protection by wearing gloves and avoid inhaling the fumes. Start scrapping the sealant as much as you can ...
You can insert shower stalls by laying a foot level on the sub-floor is level. Cut the desired length of felt roofing paper with knife to fit the shower stall. ...
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com