How to Cut 45-Degree Angles.?

1. Measure and mark in the correct position one edge of the flat side of the material, using a tape measure and carpenter's pencil. Rest a carpenter's 45-degree set square against the flat edge with the mark, so that the square's 45-degree edge faces
source: www.ehow.com
How to Cut 45-Degree Angles
Cutting a 45-degree angle through a material requires first marking the material in the correct location and at the right angle. The material can then be sawed through on the marked line using a circular saw or powered miter saw. The benefit of the miter... More »
Difficulty: Moderate
Source: www.ehow.com
Q&A Related to "How to Cut 45-Degree Angles."
 A forty five degree angle is one half of a right angle. And it is one equal angles of an isosceles right triangle. It is also a construction measurement for cornices. http://answers.ask.com/Reference/Other/what_is_a_4...
 They use a concrete saw, a gas powered saw, such as Stihl 14" Echo, Wacker. If your lucky, in your area you can buy the 45 degree blocks. http://wiki.answers.com/Q/How_do_you_cut_a_45_degr...
 1. Make sure the soda can you are going to use is half full. The precise amount in the can makes all the difference to its balancing ability. 2. Tilt the can at a 45 degree angle http://www.wikihow.com/Balance-a-Soda-Can-at-a-45-...
Top Related Searches
Explore this Topic
You can make a cut of a 45 degree angle on many different materials. A 45 degree cut will be angled slightly. A table saw is the best type of saw to use for this ...
Cutting a 45 degree angles on a table saw can be measured by putting a protractor on a piece of wood and align it properly. Using a pencil put a dot on the Forex ...
To cut 45 degree angles in quarter round, you have to measure the installation space and mark the quarter round on the edge. Then, set your saw to a 45-degree ...