How to Hook up a RPM Gauge?

Answer

To hook up a rev counter, decide where you want to mount it inside your vehicle, run the wiring into the engine, ground the black wire to the battery and find your car's ignition coil. Hook the red wire to the positive side and the green wire in the negative side of the ignition coil.
Q&A Related to "How to Hook up a RPM Gauge?"
I would suggest you try to find the manufacturer of your tachometer on the web and check out their support site and email them if needed for your particuliar vehicle. For instance
http://wiki.answers.com/Q/How_do_you_hook_up_an_rp...
1. Locate the tachometer in the desired location and attach with the hardware supplied with the kit. 2. Separate the four wires. The green wire is the tach sender wire and is to be
http://www.ehow.com/how_5504908_install-rpm-gauge....
1. Run the wiring from the gauge into the engine
http://www.chacha.com/question/how-do-you-hook-up-...
The tach signal can be picked up at the powertrain control module (PCM) located behind the left side dash. The tach wire is white in plug C2 pin #10.
http://www.fixya.com/cars/t6782548-rpm_gauge_hook_...
Explore this Topic
There can be a few reasons why the gas gauge won't work on a vehicle. This can be due to, a bad sensor, not hooked up, bad fuse and/or lost connection with the ...
A dwell meter is an automotive device. It measures RPM. To hook one up, you must attach the black and red leads to the engine. There is a specific way to do this ...
Granny Squares can be connected by crocheting granny squares using a crochet hook as part of a pattern and matching the gauge mentioned in the pattern as closely ...
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com