How to Install Brake Light Switch?

Answer

The break light switch is located behind the break pedal. Using the proper wrench remove the old switch and unplug it. Install the new switch in the reverse order.
1 Additional Answer
Ask.com Answer for: how to install brake light switch
How to Install Brake Light Switch
The brake light switch on an automobile is responsible for turning on and off the brake lights. Without the switch, the brake lights would not light up, potentially causing a rear-end collision. There is no service interval for the switch, so switches... More »
Difficulty: Moderate
Source: www.ehow.com
Q&A Related to "How to Install Brake Light Switch?"
1. Slide the push rod end of the brake light switch through the back of the mounting bracket behind the brake pedal. 2. Tighten the retaining nut on the bracket to hold the brake
http://www.ehow.com/how_5632369_install-brake-ligh...
Light switches should be installed in such a way that Live wire is connected through switch wile Neutral goes directly. Earthing should be provided for safety.
http://answers.ask.com/Consumer_Electronics/Other/...
Answer It all depends on the type of vehicle. Most of them are as follows. Disconnect the wires on the back of the switch, loosen the lock nut on the switch, unscrew the switch from
http://wiki.answers.com/Q/Brake+light+switch+on+19...
1. Locate the front brake-light switch under the right handlebar switch pod and brake master cylinder. Use a Phillips screwdriver to remove the bolt that secures the switch to the
http://www.ehow.com/how_6566967_fix-light-switch-s...
Explore this Topic
1. Slide the push rod end of the brake light switch through the back of the mounting bracket behind the brake pedal. 2. Tighten the retaining nut on the bracket ...
1. Slide the push rod end of the brake light switch through the back of the mounting bracket behind the brake pedal. 2. Tighten the retaining nut on the bracket ...
1. Slide the push rod end of the brake light switch through the back of the mounting bracket behind the brake pedal. 2. Tighten the retaining nut on the bracket ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com