How to Make a Garage Door?


To make a garage door first take measurements for the new garage doors based on the size of the existing garage doors you are replacing then decide on the design you want to use for your garage doors after deciding the size, colour, texture, material and windows, you can get a quote again build the framing to the size you need it, this can be done with any kind of treated, protected wood in any size then make sure its 2x4's are fine then cut the inserts that will make up the panels again create a groove for the panels to slip into and use wood glue on the edges before sliding them into the grooves and finally install the motorized garage door mechanisms. Then you can use the instructions that come with the set up to make sure you done it well.
Q&A Related to "How to Make a Garage Door"
1. Check the garage door's hardware. Daily use can loosen the various nuts and bolts that hold the door's sections and the track itself together. Start at one end and methodically
1. Draw a simple outline of your garage door opening on a piece of paper. Transfer all of your measurements to the appropriate area on your drawing. This is the information you will
1. Place the two 24-by-84-inch plywood (ends) on a worktable. Measure from one end and make marks at 4, 36 and 54 inches. Place the framing square on the marks and draw lines across
1. Tighten the door hardware. Before you even touch the garage door opener, go over your door hardware and make sure that the bolts on the door are all tight. If you find one that's
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014