How to Make a LED Lightbar?

Answer

To make an LED lightbar, you need to have a tube that is op[en at both ends, and then you need to put an LED in either end of the tube. Then the LEDs are turned on, the entire tube will light up.
2 Additional Answers
Ask.com Answer for: how to make a led lightbar
How to Make an LED Lightbar
LED stands for "Light Emitting Diode." It is a lighting technology that uses semiconductors to power tiny diodes that emit light as a response to an electrical impulse. LED lighting is vastly different from traditional light bulbs. There is no "bulb" to... More »
Difficulty: Moderately Easy
Source: www.ehow.com
To make an LED lightbar you will need; LED lights, a fine tip soldering iron, a case, a cover, a template for straight lines and a power supply. You will also need a wire, a clip and a multimeter. You start by drilling holes in the plate and then organizing your LED's. You can find more information here: www.youtube.com
Q&A Related to "How to Make a LED Lightbar?"
1. Lay your PVC strip on a stable work surface. Use your drill to drill holes along the length of the strip in 1/4-inch intervals. 2. Push an LED through each drill hole. Secure the
http://www.ehow.com/how_7957783_make-led-lightbar....
LED Light Bars are available for $629.99 at www.ledoutfitters.com. Thanks for using ChaCha!
http://www.chacha.com/question/how-much-are-led-li...
Whelan LED Lightbar products are available at many places online, for example the official Whelan online store or Amazon. One might also find them at a local building supplies store
http://wiki.answers.com/Q/Where_can_one_purchase_a...
In my opinion it depends upon how you expect your vehicle to be oriented on the road with respect to the flow of on coming traffic A rotating beacon may be more visible from the side
http://answers.yahoo.com/question/index?qid=200907...
Explore this Topic
1. Lay your PVC strip on a stable work surface. Use your drill to drill holes along the length of the strip in 1/4-inch intervals. 2. Push an LED through each ...
1. Lay your PVC strip on a stable work surface. Use your drill to drill holes along the length of the strip in 1/4-inch intervals. 2. Push an LED through each ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com