How to Make a Simple Amplifier?


You can make a simple amplifier with materials that you can find at a local electronics store, like Radio Shack. You will need a LM 386 semiconductor, 100 and 220 micro Farad capacitors, 10 ohm resistor, a 5 kilo ohm and 100 ohm variable resistors, a 0.01 and 0.047 capacitor, wires, 9V battery and clip, a 3.5mm stereo jack male and female, and a project board. You will need a circuit diagram in order to correctly put the components together.
Q&A Related to "How to Make a Simple Amplifier?"
1. Cut five lengths of wire, and strip 1/2 inch of insulation from the ends of each wire. Twist together one of the leads from the 5K? resistor with one end of the first wire, and
amplified reflection is a type of constructive interference that happens when two reflections are in phase with eachother. they combine and become amplified. I think.LOL.
The purpose of an amplifier is to receive a small electrical signal and enlarge or amplify it. In the case of a pre-amplifier the signal must be amplified enough to be accepted by
A "simple amplifier" simply uses a very small audio signal to control a much larger out put signal to the speakers. The simplest was probably the diaphragm and an "
Explore this Topic
You can easily build an audio amplifier with a few simple parts that you can get at any hardware or electronic store. You will also want to decide if you just ...
Installing a car amp is easy! All you have to do is follow a few simple directions (and maybe even watch a short video) which includes installing a ground wire. ...
Installing a car amp? Follow these simple directions! Disconnect the negative wire from the battery. Then run the wire through the firewall into the car. You ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014