​

How to Make a Simple Conveyor Belt?

Answer

For a conveyor belt you will need a series of rollers, frame and some strong rubber to make the belt. One of the rollers will need to be motorised if you want the belt to run on electricity. Place the rollers on the frame and cover them with the rubber. Between the rubber and the rollers most commercial conveyor belts have some sort of supporting fabric such as some kind of woven cotton. Alternatively you could use two layers of rubber. The heavier the load the stronger the belt’s support needs to be.
Q&A Related to "How to Make a Simple Conveyor Belt"
It is a pulley.
http://wiki.answers.com/Q/What_type_of_simple_mach...
1. Figure out which direction the belt should go. If the belt is tracking to the left, then you should move it to the right until it is centered. 2. Find the tracking roller, which
http://www.ehow.com/how_7977158_adjust-conveyor-be...
A conveyor belt is never simple - that is why racks with dozens of roller bearings exist - to keep from dealing with the hassles of motor drives, belt lengthening, drag on the supporting
http://answers.yahoo.com/question/index?qid=200901...
The website at .ttrca.co.uk/Trix Conveyor sheet.pdf shows you
http://www.chacha.com/question/what-website-shows-...
1 Additional Answer
To make a simple conveyor belt for kids, first gather all of the materials then nap a rim on each suspension then slip the rubber wheels onto the rims again orient the wheels so that the suspensions have the wheels both pointing the same direction then mount one of the 16-by-2 plates to the underside of the suspensions in the centre again mount the 10-by-2 stud plate on the underside of the other 16-by-2 stud plate also put the smaller plate onto the larger one so that the blocks overlap at all 20 studs and are centred again slip the edge of the 12-by-4 into the space on the 16-by-2 block so that it fits in between the gap between the 15 circles and the frame that goes around the circles also slip the opposite edge of the 12-by-4 into the gap between the studs of the 16-by-6 plate so that the majority of the plate protrudes in the direction of the wheels also put the LEGO pelvises together into a long loop by inserting the studs that normally go into the LEGO body into the underside of the feet of the next pelvis again use the craft glue to secure the joint between each pelvis where the two pelvic studs slide into the underside of the feet the wait for the glue to dry before slipping the belt onto the wheels.
​
Explore this Topic
Build a flat board with two legs to hold it up. Put rollers on either end of the board and wrap a belt around the table and over the rollers. Turn the rollers ...
Replacing a clothes dryer belt is a simple task. To begin with make sure the dryer is in area where you can manuever. Next remove all fasteners such as screws ...
In most slaughterhouses, cows and other livestock are put on a conveyor belt in a single file line. As they move through the killing room of the slaughterhouse, ...
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com