How to Repair a Seat Belt?

Answer

If a seat belt gets worn out then it should be replaced immediately. Repairs for a seat belt depend on the nature of the problem: torn belt, malfunctioning clasp, etc. If it is not feasible for you to repair the seat belt, you should buy a new one and replace it through a car mechanic.
1 Additional Answer
Ask.com Answer for: how to repair a seat belt
How to Repair a Seat Belt
In order to repair a seat belt, you must first use the proper procedure to remove the seat belt assembly. According to the I-Car website, when you repair your car seat belt, do not try to repair the seat belt retractors. Retractors that are defective... More »
Difficulty: Moderate
Source: www.ehow.com
Q&A Related to "How to Repair a Seat Belt"
1. Remove the seats and the trim panels. You may need to remove your seats and trim panels from your vehicle to gain access to your seat belt assembly. Your car repair manual will
http://www.ehow.com/how_7800257_repair-seat-belt.h...
Seatbelts have been credited for saving lives over the years. They "hold" you in place during an accident, preventing you from going out the windshield. Even if you are
http://answers.ask.com/Vehicles/Autos/why_wear_a_s...
Seat belt cannot be repaired, they MUST be replaced. They are called SAFTY belts for a good reason.
http://www.fixya.com/support/t4070808-repair_torn_...
Possible answer, but another problem. I've gotten closer to answering this question myself. The automatic seat belts were not moving at all. I checked the fuse under the dash, replaced
http://wiki.answers.com/Q/How_do_you_repair_the_au...
Top Related Searches
Explore this Topic
1. Remove the seats and the trim panels. You may need to remove your seats and trim panels from your vehicle to gain access to your seat belt assembly. Your car ...
1. Remove the seats and the trim panels. You may need to remove your seats and trim panels from your vehicle to gain access to your seat belt assembly. Your car ...
1. Check the condition of the seat belt by extending it as far as it will go. Check for any tears in the belt or damage to the connector. 2. Remove the retaining ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com