How to Stucco a Block Wall?

Answer

To stucco a block wall, first you must apply a concrete bonding agent to the block and let it completely dry. Next, apply a scratch coat (one quarter to one half inch) of stucco, and allow to partially dry. Scratch to one eight inch depth, allow to harden for forty eight hours while keeping the surface moist. Finally, a finishing coat can be applied. You can find more information here: www.doityourself.com
1 Additional Answer
First brush a concrete bonding agent on the wall to ensure the stucco will stick. Attach temporary strips of 3/8 inch strips on the top and bottom of the wall. Apply the base coat building up the stucco on the full wall. once finished used a 2/4 and ride across the temporary rails to level the surface. Remove the screeds and then float the surface. Mix and apply the finish coat. You can find out more information here: www.taylorrental.com
Q&A Related to "How to Stucco a Block Wall?"
1. Pound small wooden stakes into the ground to mark the wall's ends, using a mallet. String a piece of twine between the stakes to mark where to dig the trench. 2. Lay out a row
http://www.ehow.com/how_6522494_build-block-wall-s...
Stucco can be applied on indoor and outdoor walls. Stucco application will cover up the worst of damaged walls, as well as adding a unique new look, and only requires a few painting
http://answers.ask.com/Home/Other/how_to_stucco_a_...
Applying stucco to exterior walls is a good way to change the appearance. Stucco is a cheap way to update as well. In order to apply stucco you first need to clean the walls and add
http://www.ask.com/answers/95915881/how-to-stucco-...
Road-map walls and ceilings can be impossible to repair, but they're very easy to disguise. Hide the cracks and give the room a new look with stucco paint. Tools: Bucket and sponge.
http://www.howstuffworks.com/how-to-install-wall-t...
Explore this Topic
Stucco provides an attractive surface for cinder blocks. Portland cement plaster can be used for a base coat. Stucco should be applied in mild weather and one ...
1. Wash and dampen the wall by spraying it down with a garden hose, using enough water so the moisture actually penetrates the surface of the block. The surface ...
Before you apply stucco to a cinder block wall, pressure wash the wall to remove all dirt and finishes. Mix the stucco in a wheelbarrow, and apply the stucco 1 ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com