How to Thread a Weed Eater?

Answer

In order to restring or thread a weed eater, you need to take the bottom portion of the weed eater off. Usually, you simply need to push inwards and turn the weed eater in a counterclockwise direction. The minimal length of the string that you should use for your weed eater is around 6 inches.
Reference:
Q&A Related to "How to Thread a Weed Eater?"
1. Unplug or disconnect the spark plug cable on the weed eater. This prevents the tool from turning on unexpectedly. 2. Unscrew the cap on the weed eater head. 3. Remove the old spool
http://www.ehow.com/how_7658950_thread-weed-eater-...
how thread a twist'n edge weed eater rte115.
http://wiki.answers.com/Q/How_to_thread_an_twist_'...
1. Place the Weed Eater trimmer on its side on a flat surface with the air filter cover pointing up. 2. Hold the dust cup nut with an adjustable wrench to keep the shaft from moving
http://www.ehow.com/how_6623326_remove-head-weed-e...
1. Place the Ryobi weed eater on its side on a flat surface with the gas filler cap pointing toward you. This will prevent accidental fuel spillage. Grab the end of the spark plug
http://www.ehow.com/how_6324154_install-string-ryo...
1 Additional Answer
Ask.com Answer for: how to thread a weed eater
How to Thread a Weed Eater
A weed eater, or lawn trimmer, is typically loaded with a long string of twine that sticks out of either side of a small twine housing located at the end of the weed eater. As the housing spins, the twine easily cuts through grass, leaving your lawn neat... More »
Difficulty: Moderately Easy
Source: www.ehow.com
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com