How do you wire 277 volts?

Answer

The most common method is called the three phase, three wire power. You can also use a autotransformer to do the conversion. You could also use the same wattage for wiring.
Q&A Related to "How do you wire 277 volts?"
A voltage of 277 is the line to neutral voltage of a 480 volt wye three phase system. L1- N, L2 - N and L3 - N will give you 277 volts. L1 to L2. L2 to L3 and L3 to L1 will give you
http://wiki.answers.com/Q/How_to_wire_277_volt_lig...
1. Test your power source with a multi-meter. Set the range selector to DC 12V and place one probe on each power source lead. With the positive probe on the positive power source
http://www.ehow.com/how_12008283_wire-12volt-led.h...
Is it just an incandescent lamp? If so, there's no need to do anything, just connect it. Across the legs, grounding the fixture, and you'll be good, most likely. It won't be QUITE
http://www.webanswers.com/home-garden/utilities-el...
1. Open the battery box and remove the cable on the positive terminal of the first battery with the socket set. Run the red wire from the trolling motor and connect it and the positive
http://www.ehow.com/how_8788257_wire-volt-evinrude...
3 Additional Answers
When you are wiring 277 volts it is best to follow a diagram, instructions and also what is listed in the manual. This will allow you to correctly wire the volts.
You can wire 277 volts, by running a cable from your 277 volt outlet to your 440 amp breaker box. The 277 volt outlet will need to be grounded to a metal pole in the ground.
To wire 277 volts, you must first find out if the device is a 2-wire 277, or a 3-phased 277 volt device. Pull two wires for a 277 device from the breaker panel, to the device. Hook the two wires from the device to the wires you pulled. Hook the other two wire into the panel box on the breakers.
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com