How to Wire an Automotive Toggle Switch?

Answer

To wire a toggle switch to a car, you will have to drill a hole under the dash to place your switch. Next connect the in-line fuse to a hot terminal on the car's fuse panel. Connect another wire from your device to the terminal on the switch. Tuck all the loose wired under the dash and secure them.
Q&A Related to "How to Wire an Automotive Toggle Switch?"
A toggle switch is a single contact open/close circuit switch. Normally the wire from the power source is connected to the primary of hot side of the switch and the ground is connected
http://answers.ask.com/Consumer_Electronics/Other/...
1. Disconnect the cable connected to the positive terminal of the car's battery. 2. Find the power cabling for the device you wish to control with a toggle switch. 3. Cut the negative
http://www.ehow.com/how_8596700_use-automotive-tog...
my ignition is broke and on the on position how can i bypass the ignition n use a toggle for power and a pushbutton to start
http://wiki.answers.com/Q/Your+ignition+is+broke+h...
Ok you need to put power from the fuse box to the switch and then use the other hook up on the switch to run a wire to the lights.Hood this wire to the red or + wire on the lights
http://answers.yahoo.com/question/index?qid=201012...
Explore this Topic
When you are wiring a toggle switch you will need to locate the fused line. The next step is to locate the toggle switch and drill a hole in it. ...
1. Toggle switches can control multiple devices or circuits. Connect the source wire to one terminal. This wire will route the voltage or signal to the switch. ...
Basic toggle switches are pretty simple to wire. One wire attaches to one prong while another wire attaches to the second prong. One wire will go to a battery ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com