How to Flush the Radiator in a Mercury Villager?

Answer

A person can flush the radiator in a Mercury Villager by parking on level surface. The radiator cap should be turned to relieve pressure. The drain plug also needs to be opened.
Reference:
Q&A Related to "How to Flush the Radiator in a Mercury Villager..."
1. Disconnect the negative battery cable being careful to avoid contact with metal parts. Remove two screws from the right side and two more from the left side of the bottom center
http://www.ehow.com/how_4484470_install-stereo-mer...
ford lincoln
http://wiki.answers.com/Q/What_make_is_mercury_vil...
I'm going to assume you mean the heater core, the part that is on the inside of the car to keep you warm. If you are internet capable, go to www.partstrain.com ($120.00) or www.silverstatefordparts.com
http://wiki.answers.com/Q/How_much_is_a_heating_co...
There are no bleed valves on the engine, if that is what you mean.
http://wiki.answers.com/Q/Where_is_bleed_valves_on...
Explore this Topic
1. Raise the van securely on a jack stand and remove the wheel. 2. Disconnect the brake hose from the caliper at the fitting bolt. Discard the old washers on the ...
1. Place the shift lever in the "Park" position on automatic vehicles and "First" gear on manual vehicles and the parking brake on. Ford recommends ...
1. Raise the van securely on a jack stand and remove the wheel. 2. Disconnect the brake hose from the caliper at the fitting bolt. Discard the old washers on the ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com