When the ignition switch is turned to lock?
Answer
The key can only be removed from the 'Lock' position. When this occurs, all non-essential electrical circuits are disabled, and the steering column lock is enabled. If fitted, the engine immobilizer and theft deterrent systems are normally activated at this time.
Q&A Related to "When the ignition switch is turned to lock?"
|
Why the key does not turn may depend on a couple factors. If this is an older vehicle that does not have a locking steering column, the switch most likely has a bad tumbler or a foreign
http://wiki.answers.com/Q/Why_key_ignition_switch_...
|
|
you need to be more specific. i am going to assume you want to know in what position is the ignition switch in lock. usually it is 2 positions back from "run" but it is
http://wiki.answers.com/Q/When_the_ignition_switch...
|
|
The ignition switch is responsible for more than just starting your car. It prevents the unauthorized turning of the steering wheel, and it supplies nearly half of the cars power
http://answers.ask.com/Vehicles/Autos/how_to_chang...
|
|
Disconnect the battery, remove the steering wheel by taking off the center cover,take off the switches to the windsheild wipers and turn singals,unscrew the ignition switch, insert
http://answers.ask.com/Vehicles/Autos/how_to_insta...
|
Similar Questions
People Also Asked
Wikipedia on Ask.com
A key is an instrument that is used to operate a lock (device). A typical key is a small piece of metal consisting of two parts: the blade, which slides into the keyway of the lock and distinguishes...
Top Related Searches
Explore this Topic
To troubleshoot a Ford ignition switch, you can listen carefully while turning the key in the ignition for a clicking noise. If there's no clicking, the switch ...
1. Insert your key into the ignition keyhole and jiggle the wheel back and forth while trying to turn the ignition switch. Sometimes, the steering wheel lock prevents the ignition from being turned properly. 2. Spray brake parts cleaner into the igni ...
1. Spray a liberal amount of WD-40 into the keyhole of the ignition switch. 2. Push the key in and pull it out several times to work the pins in the tumbler so that the lubricant gets spread around inside the switch assembly. 3. Turn the ignition key ...