How to Make a Plate Hanger?

Answer

1. Clean the back of the plate to remove dirty.2. Use fint grit sandpaper to sand about 1' ring in the plate (sand away from the ring) only takes about 10 seconds less to do.3. Place a small amount (like dot) of super glue (use super glue that can be used on glass/plate like E6000)4.Take a safety pin head (metal part) place it in the super glue, make sure that the bottom of the safety pin that has the little circle goes up and over the ring.5. Cover the head of the safety pin with super glue; glue should be on all sides of the safety pin.6. Let the glue dry, probably for several hours.7. You can test the plate hanger by placing a pillow or blankets on the floor and place your plate hanger on the wall securely to make sure it will hold up.
Q&A Related to "How to Make a Plate Hanger?"
1. Cut two pieces of wire 3 inches longer than the diameter of the plate. 2. Twist one piece of wire to form a circle in the center of the long wire section. 3. Bend the second wire
http://www.ehow.com/how_6562594_make-plate-hanger....
You may purchase plate hangers from websites such as eBay, and Overstock. You may also find them locally at big box stores such as Wal-Mart, and Canadian Tire.
http://wiki.answers.com/Q/Where_can_one_purchase_p...
The plate hanger likely has two portions made of wire that hook opposite edges of the plate. A pair of springs pull the wire portions together to hold the plate in place. Look at
http://answers.yahoo.com/question/index?qid=201209...
When using this website please use common sense. The information provided on this site is intended for your general knowledge only and is not a substitute for professional advice.
http://www.helpfulbox.com/ans/Home_Garden/306591
Explore this Topic
You can make a plate hanger by embellishing a window frame by adding vertical wooden shelves to create a rack. You can hang individual plates by using superglue, ...
1. Cut two pieces of wire 3 inches longer than the diameter of the plate. 2. Twist one piece of wire to form a circle in the center of the long wire section. 3 ...
1. Cut two pieces of wire 3 inches longer than the diameter of the plate. 2. Twist one piece of wire to form a circle in the center of the long wire section. 3 ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com