How do you reset your Kenwood CD player code?

Answer

If it becomes necessary to reset your Kenwood CD player code, there are some steps you need to take. Start your vehicle and press the > > and Auto keys at the same time, holding for around 5 seconds. Press the number 5 on your remote two times and press > > on the stereo. Press 2 on the remote three times then press > > on the stereo again. Once again, press 2 on the remote.
Q&A Related to "How do you reset your Kenwood CD player code?"
1. Buy a Kenwood Stereo remote control if you do not have one. The Kenwood store website is listed in the resources section of this article. 2. Start your car. Then, press the "
http://www.ehow.com/how_5164864_reset-kenwood-cd-p...
I blew an engine fuse on my Miata and my Kenwood KDC-X859 went into the theft security mode when I reconnected it to power. After a lot of research and trial-n-error I was able to
http://wiki.answers.com/Q/You+have+the+code+for+ke...
you cannot reset them freely if you could would pose massive security risk if stolen.
http://www.fixya.com/support/t6238069-reset_securi...
(716) 856-7800 that's the number for customer support. They should address your concerns there.
http://answers.yahoo.com/question/index?qid=201108...
1 Additional Answer
If it becomes necessary to reset your Kenwood CD player code, there are some steps you need to take. Start your vehicle and press the > > and Auto keys at the same time, holding for around 5 seconds. Press the number 5 on your remote two times and press > > on the stereo. Press 2 on the remote three times then press > > on the stereo again. Once again, press 2 on the remote.
About -  Privacy -  Careers -  Ask Blog -  Mobile -  Help -  Feedback  -  Sitemap  © 2014 Ask.com