How to Thread a Weed Wacker?

Answer

When restringing a weed wacker, disconnect the trimmer line if it is electrical and the attaching nut, holding the spool. Do away with the useless spool and wrap another line tying the spool towards where the arrows of the spool are heading to. Start another line at the line hole, allowing a 15.2 cm gap where the line will pass. Return the spool on its position and tighten it.
Q&A Related to "How to Thread a Weed Wacker?"
1. Unplug your line trimmer if it is electric. If it is gas, pull the spark plug cap off for safety reasons. 2. Undo the lock nut that holds the spool or head on. If it is on too
http://www.ehow.com/how_5635299_thread-weed-wacker...
To replace a string weed wacker, first turn off the weed wacker. Then remove the trimmer head beneath the weed-trimmer. Remove the old trimmer line by either untying the old line
http://www.ask.com/question/how-to-string-a-weed-w...
The oil ratio will vary depending on the make and model of the engine. I recommend that you call a small engine repair shop that services your brand of weed wacker and they can tell
http://wiki.answers.com/Q/What_is_the_oil_ratio_fo...
A gasoline weed whacker is 100 to 105 decibels. To put that in perspective, a lawn mower
http://www.chacha.com/question/how-loud-are-weed-w...
Explore this Topic
Restringing a weed eater is often needed when something gets caught up in the string inside the weed eater. First the spool cover needs to be removed along with ...
To replace a string weed wacker, first turn off the weed wacker. Then remove the trimmer head beneath the weed-trimmer. Remove the old trimmer line by either untying ...
1. Turn the Week Wacker upside down so that the spinning base faces upward. 2. Depress the two clips on either side of the spinning mechanism on the Weed Wacker ...
About -  Privacy -  AskEraser  -  Careers -  Ask Blog -  Mobile -  Help -  Feedback © 2014 Ask.com