Tweet
Test Ignition Coil?
Answer
The test for an ignition coil begins with disconnecting the coil output wire. Then a person will have to hook a spark plug to the output wire making sure that it is grounded. This is basically a test that can hurt if done wrong so it is best that it is done by a mechanic. It involves looking for sparks.
1 Additional Answer
You can test ignition coils by using an ohmmeter. With all of the wires disconnected, the ignition coils should read between 0.75 to 0.81 ohms of resistance.
Q&A Related to "Test Ignition Coil?"
|
1. Use a wrench to loosen the bolt on the negative battery cable and set the cable aside in a spot that will not allow it to touch the battery while you are working. 2. Locate the
http://www.ehow.com/how_5935714_test-ignition-coil...
|
|
1. Open the hood, and locate the ignition coil pack by tracing the spark plug wires from the spark plus, which are located on top of the engine, to the ignition coils, which are usually
http://www.ehow.com/how_7949394_test-maxima-igniti...
|
|
1. Open the hood of the vehicle. Check your owner's manual for the ignition system wiring diagram to locate the power cable that feeds the ignition system. 2. Touch the test light
http://www.ehow.com/how_7905332_test-ignition-coil...
|
|
1. Disconnect the negative battery cable, using a wrench or socket and ratchet. Move the cable away from the battery while you are working. 2. Locate the coil in your vehicle's engine
http://www.ehow.com/how_5981166_test-ford-ignition...
|
Similar Questions
People Also Asked
Wikipedia on Ask.com
Nuclear weapons tests are experiments carried out to determine the effectiveness, yield and explosive capability of nuclear weapons. Throughout the 20th century, most nations that have developed nuclear...
Top Related Searches
Explore this Topic
To test a faulty ignition coil wire, disconnect the ignition coil output wire at the distributor cap. Connect a spark plug to the end of the disconnected ignition ...
1. Remove the ignition coil wire from the ignition coil and distributor cap terminals. 2. Attach one lead from the test light onto each metal terminal of the wire. If the bulb does not light up, you already know the wire is faulty. 3. Wiggle the wire ...
You can test a electronic ignition coil by seeing if the primary resistance is in between the two primary coil terminals. You will test that when the coil connector ...