What is a Toggle Switch?
Answer
A toggle switch is a manually operated switch that uses a lever, handle or rocking mechanism to control the flow of electricity from a power supply. A toggle switch can be used either for commercial purposes or in a residential setting.
Ask.com Answer for: what is a toggle switch
What Is a Toggle Switch?
A toggle switch is a mechanism that does one of only two things: "On" and "Off." The familiar bat-handle switch might provide power to a piece of farm equipment, or nestle among many switches and dials on an airplane control panel. Other examples are the...
More »
Difficulty:
Easy
Source:
www.ehow.com
Q&A Related to "What is a Toggle Switch"
|
A toggle switch is a single contact open/close circuit switch. Normally the wire from the power source is connected to the primary of hot side of the switch and the ground is connected
http://answers.ask.com/Consumer_Electronics/Other/...
|
|
Toggle switch has a Pole & Throw. Supply or Phase should be connected to Pole. Load or device should be connected to Throw. Switch must sustain load current.
http://answers.ask.com/Consumer_Electronics/Portab...
|
|
1. Shut off or disconnect the power supply and strip 1/4 inch of the insulation off the power supply wire with wire strippers. Strip the end of the hot wire from the device that will
http://www.ehow.com/how_7824732_connect-toggle-swi...
|
|
The noun "toggle" refers to a pin or knob that keeps something fastened, with applications in the nautical, fashion and carpentry worlds. A knot with a toggle will not untie
http://www.ehow.com/about_5041196_toggle-switch.ht...
|
Similar Questions
People Also Asked
Wikipedia on Ask.com
In electrical engineering, a switch is an electrical component that can break an electrical circuit, interrupting the Electric current or diverting it from one conductor to another.
The...
Top Related Searches
Explore this Topic
To wire a toggle switch to a car, you will have to drill a hole under the dash to place your switch. Next connect the in-line fuse to a hot terminal on the car's ...
A person can hook up a toggle switch by removing any source of power. Wire strippers should be utilized to strip insulation. A soldering iron should also be utilized ...
1. Turn off all power to the room at the fuse box. Remove the light switch plate with your screwdriver. Take out the switch assembly by unscrewing the screws holding it on top and bottom. Pull it out from the electrical box. 2. Take note of where all ...