|
1. Connect one end of the cable into the computer's network card. Above is the image of a data cable connector. This fits into the network card's port installed in the computer. Both
http://www.ehow.com/how_6169600_connect-data-cable...
|
|
1. Cut the cable to the desired length. It is a good idea to leave a few extra inches at both ends in case the process has to be repeated in the event of an error. 2. Cut and remove
http://www.ehow.com/how_7298848_wire-data-cable.ht...
|
|
1. Place the box of cable at the origination point. This is the central point where all the cables will run back to. It is often a small room where the network equipment will be set
http://www.ehow.com/how_5925372_install-data-cabli...
|
|
1. Insert any software required to use your device, such as a printer, MP3 player, scanner, PDA and cell phones. This will allow your computer to recognize the device once it's connected
http://www.ehow.com/how_5708698_use-data-cable.htm...
|