Topic: 1988 Honda Accord LX
Not finding your answer? Try searching the web for 1988 Honda Accord LX
Answers to Common Questions
How to Troubleshoot No Spark in a 1988 Honda Accord LX
A common problem with late 80's and early 90's Honda cars, including the Accord, is a faulty distributor. There are several things to check before condemning the distributor however, and a process is needed to pinpoint the exact cause of th... Read More »
Source: http://www.ehow.com/how_6502581_troubleshoot-1988-honda-accord-lx...
Where are the fuel filters on a 1988 Honda Accord LX?
One is in the front engine compartment. It is close to the driver's side rear corner of the engine compartment close to the master cylinder. The other fuel filter is located at the fuel tank. You must jack the car up and remove the driver's... Read More »
Source: http://wiki.answers.com/Q/Where_are_the_fuel_filters_on_a_1988_Ho...
Where is the starter on a 1988 Honda Accord LX?
On the left hand side of the motor(passenger side), above the transmision, abd below the thermostat housing... Dunno if mine is factory or not, but it is this lime green color, really easy to spot Read More »
Source: http://wiki.answers.com/Q/Where_is_the_starter_on_a_1988_Honda_Ac...
Featured Content:
1988 Honda Accord LX
More Common Questions
Answers to Other Common Questions
The 1988 Accord uses an electric fuel pump which is installed in the gas tank. The fuel pump delivers fuel from the gas tank to the engine. A fuel pump may continue to function yet still need to be replaced. If the fuel pump is not operatin...
Read More »
Source: http://www.ehow.com/how_6897455_do-1988-honda-accord-lx_.html
this guide is for replacing the clutch in a 1988 Honda accord dx. lx may vary. also this is removing the tranny via the bottom not through the top. first of course take out the battery of course. also dis connect the coil distributor wire. ...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_replace_clutch_in_a_1988_hon...
Take the motor mounts off and take it out of the wheel well of ht driver side Answer I did not remove mine. Instead, I replaced the brushes with the alternator still in place. It was a lot cheaper and easier. Answer Take the motor mounts ...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_replace_the_alternator_on_a_...
Answer If adjusting the idle speed isn't working, check the choke. If that's not it, check the carberator chain. It's a fairly common problem, though the answer usually differs.
Read More »
Source: http://wiki.answers.com/Q/How_do_you_lower_the_rpm's_in_a_carbera...
They came stock with around 110-120 hp.
Read More »
Source: http://wiki.answers.com/Q/How_much_horsepower_does_a_1988_honda_a...
Answer Don't understand your question. Are you asking how to gap the plugs. The proper gap is listed in your owner's manual and under the hood on a placard. Most plugs come pre-gapped. To check and adjust the gap, use a tool designed for th...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_space_spark_plugs_for_a_1988...
