Topic: Base Burette
Not finding your answer? Try searching the web for Base Burette
Answers to Common Questions
What is a base burette?
bwisit wala bang matinong sagot dito??? putik niyan gumawa pa kayo ng website na ganto!!!!!!!!!!!!!!!!!!!!!!!!!!!!! f.u/ Read More »
Source: http://wiki.answers.com/Q/What_is_a_base_burette
What is the use of acid and base burette?
The general use of acid/base burettes I am familiar with is to determine the concentration of either the acid or base from the known concentration of the other solution. The two burettes are set side by side, and a quantity of acid is place... Read More »
Source: http://wiki.answers.com/Q/What_is_the_use_of_acid_and_base_burett...
What base burette and how it used?
Base burettes are used for base titrants. Basically this is used in titrations where the analyte is an acid. Read More »
Source: http://wiki.answers.com/Q/What_is_a_burette_and_how_it_is_to_used
More Common Questions
Answers to Other Common Questions
If you have an acid in your conical flask then the base will go into the burette. The burette is used to measure the amounts of base you are adding and therefore you will be able to determine the end point which is normally determined by a ...
Read More »
Source: http://wiki.answers.com/Q/What_is_the_use_of_an_acid-base_burette...
For the titration of a base with an acid it is normal to have the acid in the burette and the basic solution in the Erlenmeyer (or Berzelius) flask. For the titration of an acid with a base it is normal to have the base in the burette and t...
Read More »
Source: http://wiki.answers.com/Q/Why_it_is_preferred_to_take_acid_in_bur...
1. To make sure what you're filling the burette with all goes inside the burette and not all over your lab table. 2. More importantly, the portion of the burette at its top, above the first measurement mark, must remain dry. If any drops of...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20120223123823AAjiP9E
Not always; I have done titrations with alkali in the base vessel and the acid in the burette. It can be done either way around.
Read More »
Source: http://answers.yahoo.com/question/index?qid=20111110143837AAbkFYB
1) Bases like NaOH or KOH attack glass, so you don't want to corrode your burette with time. 2) Sometimes basic solutions form crystals on the burette tip and the hole becomes clogged. Crystal formation is directly proportional to base conc...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20060916000647AAxvsFQ
to neutralize the solution, or to adjust a certain pH in which an appropriate indicator gives a color change. neutralization gives a definite and known yield, avoiding some side reaction.. therefore, acid - base reaction is used in titratio...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20100501230319AAizEgH
In a standard acid-base titration, you have an acid sample and you want to figure out how many moles of acid are in it. You do this by reacting the sample with base until the pH=7, at which point the moles of base added equals the moles of...
Read More »
Source: http://en.allexperts.com/q/Chemistry-including-Biochemistry-1355/...
