Topic: Bore X Stroke Conversion
Not finding your answer? Try searching the web for Bore X Stroke Conversion
Answers to Common Questions
What does bore x stroke mean?
Bore = the (internal) diameter of the cylnder hole in the engine block. Stroke = the distance the piston travels up (or down) the bore during its' cycle. If you multiply the bore dimension by the stroke dimension you will get the volumetric... Read More »
Source: http://wiki.answers.com/Q/What_does_bore_x_stroke_mean
What does it mean by define an engine by its Bore X stroke?
bore is the diameter of the piston and stroke is the length the piston moves in the cylinder.for example if bore x stroke is 1x3 then 1 is the diameter of the piston and 3 is the length of the cylinder.if bore is greater than stroke then it... Read More »
Source: http://wiki.answers.com/Q/What_does_it_mean_by_define_an_engine_b...
What is the bore and stroke of a Honda 350x?
Piston...................68mm crank (stock).............74mm (6mm)st... Read More »
Source: http://www.chacha.com/question/what-is-the-bore-and-stroke-of-a-h...
More Common Questions
Answers to Other Common Questions
What that is used for is to figure out the displacement of a cylinder in an engine. You would then multiply your answer X number of cyclinders and you have the displacement of your engine (5.2 liter or 318ci) Bore is the measured diameter o...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20061217074200AARSZn6
A 4.060 bore with a 3.75 stroke is 388. A 4.060 bore with a 350 crankshaft is 360. yes the cubic inches of a chevy small block with a 4.060 bore and a 3.75 stroke would have 388.4 cubic inches of desplacement however if you have a 4.060 bor...
Read More »
Source: http://wiki.answers.com/Q/What_would_a_4.060_bore_x_3.75_stroke_w...
A high power 4-stroke bore x stroke 57.4 x ...
Read More »
Source: http://www.chacha.com/question/how-fast-can-a-high-power-4%26%234...
Bore is the inside diameter of the cylinder. Stroke is the distance the piston moves from the bottom of the cylinder bore to the top. It's not a question of being okay or not. These are the dimensions of the cylinder that the manufacturer c...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20111207075350AA7LDZ8
thank you guys for the info. spedur
Read More »
Source: http://www.smokstak.com/forum/showthread.php?t=60090
4.125 x 3.600 gives you 384. 4.155 x 3.600 gives you 390. Both are very torquey combinations and capable of high RPM use. Grinding a 3" main to 2.500 is not wise as you'll move the rod journal oil holes away from the center of the main. By ...
Read More »
Source: http://www.realoldspower.com/phpBB2/viewtopic.php?p=612262
