Topic: Box Culvert
Not finding your answer? Try searching the web for Box Culvert
Answers to Common Questions
How to Clean Box Culverts
Box culverts are made from materials including steel and precast concrete. Culverts are used to channel water underneath construction such as roads, buildings and green space. This solution to water management is prefabricated and then inst... Read More »
Source: http://www.ehow.com/how_8672152_clean-box-culverts.html
How to Load Railroad Box Culverts
Railroad box culverts are often used in place of round culverts below railroad tracks because of all the additional weight they can support. However, when loading these culverts it's important that you calculate how much load the culverts c... Read More »
Source: http://www.ehow.com/how_12034538_load-railroad-box-culverts.html
How to Construct a Box Culvert Bridge
When streams, drainage areas and overflow ditches cross paths with driveways, small roads or embankments, a box culvert bridge is one practical and long-lasting solution to the problem. A culvert is just a fancy name for a channel through w... Read More »
Source: http://www.ehow.com/how_5599492_construct-box-culvert-bridge.html
Featured Content:
Box Culvert
More Common Questions
Answers to Other Common Questions
Box culvert can be described as either a precast concrete or reinforced concrete structure in rectangular figure, facilitating water flow through an embankment of road,etc,as a similar function performed by concrete pipe culvert.
Read More »
Source: http://wiki.answers.com/Q/What_is_box_culvert
Box culverts let water through your property while still allowing you to make use of space. A box culvert will occassionally get clogged, as the water running through it brings gravel, sticks and other debris through it. A clogged culvert c...
Read More »
Source: http://www.ehow.com/how_8762418_remove-gravel-box-culverts.html
Hi Esther, They are designed differently, as circular one mainly work by radial compression whilst ractangular ones work by bending/shear. The rectangular ones have more capacity per unit height and use less fill above if crossed by a road....
Read More »
Source: http://en.allexperts.com/q/Civil-Engineering-1357/2011/1/irrigati...
Pipe culverts are easier to install since they are manufactured at a casting yard and shipped to the site ready to lay. The disadvantage of pipe culverts is that you will need more of them to handle a certain flow (cubic feet/sec) and you m...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070306050440AArvFQL
Look on page 6 of this PDF http://www.humes.com.au/fileadmin/templa…
Read More »
Source: http://answers.yahoo.com/question/index?qid=20120203225719AA2eKSu
You mean like this? Shouldn't be too hard to scratchbuild out of styrene. it's what, 8-10 scale feet tall, so that'd be about 3/4 inches tall. If you're OK with it also being 10 feet wide, Plastruct has some 3/4" ABS rectangular tubing that...
Read More »
Source: http://www.nscale.net/forums/showthread.php?17639-How-do-you-make...
