Topic: Bridging Subs
Not finding your answer? Try searching the web for Bridging Subs
Answers to Common Questions
How to Bridge an 8-Ohm Sub
Amplifier bridging is a subwoofer wiring technique which consists of using multiple channels of a multichannel amplifier to drive a single load. Amplifier bridging provides a higher total output compared to the output of the individual chan... Read More »
Source: http://www.ehow.com/how_8485012_bridge-8ohm-sub.html
How to Bridge Two 12-Inch Subs
Any car audio enthusiast will tell you that a good sound system needs serious bass, and while a system with a single subwoofer can sound good, a system with two 12-inch subs can sound great. But what if you already have a single subwoofer i... Read More »
Source: http://www.ehow.com/how_8408514_bridge-two-12inch-subs.html
How to Bridge Mono Amp for Two Subs
One of the most common questions posed by those putting together a car audio system is how to add additional subwoofers into their system. There are many different wiring configurations and schemes that can be employed depending upon the am... Read More »
Source: http://www.ehow.com/how_5957943_bridge-mono-amp-two-subs.html?ref...
More Common Questions
Answers to Other Common Questions
In most installations, four subwoofers result in solid, powerful bass. One way to install these woofers is with the use of a two-channel amp, bridged to increase power output. Surprisingly, wiring of these woofers is not extraordinarily com...
Read More »
Source: http://www.ehow.com/how_6589002_bridge-4-subs-2_channel-amp.html?...
There are numerous car audio amplifier wiring methods to allow technicians to fully use an amplifier's power. Bridging is one such wiring tactic employed by many car audio enthusiasts who wish to send extra power from their amp to a subwoof...
Read More »
Source: http://www.ehow.com/how_6934286_bridge-channel-amp-1-sub.html
3 parts to a bridge. Foundations - Anything below the ground. Sub Structure - Columns, piers, support structures Super Structure - Bridge deck
Read More »
Source: http://wiki.answers.com/Q/What_is_sub_structure_and_super_structu...
You would need to connect left positive to positive on speaker, right negative to negative on ...
Read More »
Source: http://www.chacha.com/question/how-do-you-bridge-subs
3 passive sub at 8 ohm imp in parralel will be 2.6+ impedence.Most of the professional sum amp can take up to 2 ohms load per channel(check the spec of the Amp)eg: you should be able to connect max 4 subs in each channel(match the watts pwr...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_bridge_three_subs_to_a_two_c...
Your amp must be bridgeable first of all and it should show you on the amp, most do but you put the + on ch. 1 and the - on ch. 2 sometimes the othrr way around.
Read More »
Source: http://wiki.answers.com/Q/How_do_you_bridge_a_two_channel_amp_to_...
You bridge the amp not the sub.
Read More »
Source: http://wiki.answers.com/Q/How+do+you+bridge+only+one+sub
