A CB radio is simple to install. All this needed is to connect the power by connecting the black wire to ground and the red wire to a +12 volt source. Next, connect the antenna and microphone. Select a channel and request a "break"...
http://answers.ask.com/Consumer_Electronics/Other/how_t...
I have many radios I have collected over the years from other cb operators,garage sales,second hand shops,and internet classified ads,,all at good cheap prices.As a matter of fact I just bought two hardly used radios from a guy for ten buck...
http://answers.yahoo.com/question/index?qid=20080529182...
The site says pin-end, I will assume that means the plug is facing YOU. I'll solder it that way and wait for a confirmation reply before plugging it in. blackjackel 6 PILL USER Posts: 73 Age: 26 Joined: Saturday, 07 February 2009, 9:58 AM ...
http://www.cbradiotalk.com/viewtopic.php?f=32&t=30141&s...
In many cases yes, but not always and it is still good to me respectful and mindful of that I'd guess. In this day and age though, some of the "loud overmodulated and bleeding" operators on CH.11 would still bleedover and wipe o...
http://www.cbradiotalk.com/viewtopic.php?f=8&t=28814
Several people use the Cobra 75 and the only thing you have to mount is the speaker portion. The main unit gets tucked in out of the way. You can serch the forum and find several hits on it.
http://www.jk-forum.com/showthread.php?t=63011
Not much use unless you're near and use interstates that are fairly busy. Even then it's mostly just truckers asking for the same old directions and trash talking. It depends on what channels you listen to. There are more people on there th...
http://forums.vwvortex.com/zerothread?id=4504043&postid...
IP is here and offers more than hybrid or analogue systems. So Mark Harraway argues here. Mike Tennent of Tavcom Training sets out the next part of his response below. Progress for the CCTV industry is still in an embryonic state and we mus...
http://www.blogcatalog.com/topic/tavcom+training/