・ A CO2 dragster is a small model car powered by compressed carbon dioxide gas. A canister of CO2 is put... ・ The gas inside the CO2 canister is at much higher pressure than the outside atmosphere. When the canister... ・ Newton's third law ...
http://www.ehow.com/how-does_5030050_co-dragster-powere...
・ 1 Sand any rough or jagged edges with sandpaper until smooth. ・ 2 Apply a coat of sanding sealer to the dragster and allow it to dry. Repeat this application twice to... ・ 3 Paint the car with craft paint. Allow the paint to dry and then ...
http://www.ehow.com/how_5175410_paint-co-dragster.html?...
Make it very aerodynamic and light by making it hit the wind easily
http://wiki.answers.com/Q/How_do_you_build_a_fast_co2_d...
make it more aerodynamics so the winds don't hold the car back when it is racing
http://wiki.answers.com/Q/How_do_you_make_a_CO2_dragste...
Yes and no. if you position the axle too far forward the weight of the CO2 cartrige will cause it to tip back. This will create greater friction on the eye screws and slow down your car. but if the axles are further back than it won't tip u...
http://wiki.answers.com/Q/Is_it_possible_to_make_the_co...
Bike tire inflators can do it. However you do it, though, PLEASE make sure you cannot get the bare CO2 cartridge flying about - serious injury risk.
http://answers.yahoo.com/question/index?qid=20071128160...
Keep total weight to a minimum while maintaining sufficient strength to keep the thing together. Make the wheels as large in diameter as practical, while still keeping them thin and light. The wheels should be made from a hard material, for...
http://answers.yahoo.com/question/index?qid=20080407102...