Topic: Cisco Router Commands
Not finding your answer? Try searching the web for Cisco Router Commands
Answers to Common Questions
What command enables a DHCP relay on a Cisco router?
hal-loosi Read More »
Source: http://wiki.answers.com/Q/What_command_enables_a_DHCP_relay_on_a_...
What does the enable command do in a cisco router?
The "enable" command will bring the privilege level from user exec to privileged exec. Example: R1> R1>enable R1# Read More »
Source: http://wiki.answers.com/Q/What_does_the_enable_command_do_in_a_ci...
What Is a Cisco Router?
Cisco Systems has been in the networking business for a long time and is now offering routers for the secure delivery of concurrent data, voice, video and wireless services. The Cisco Carrier Routing System (CRS-1) is one of the Internet ro... Read More »
Source: http://www.ehow.com/about_5072699_cisco-router.html
More Common Questions
Answers to Other Common Questions
In order to repair a Cisco router, methodical troubleshooting methods need to be implemented to diagnose the hardware and configurational problems. An advance knowledge of system error codes in the warning messages is needed to determine wh...
Read More »
Source: http://www.ehow.com/how_7458974_repair-cisco-routers.html
A properly configured Cisco router will be able to install a password, set the hostname and Internet Protocol (IP) address, along with the subnet mask that will dictate the behaviors of the router device. Failure to properly configure and s...
Read More »
Source: http://www.ehow.com/how_5544357_configure-cisco-router.html?ref=T...
Programming your new Cisco router is step one in configuring your home network. This will enable you to connect your other home computers to the router in order to share your Internet, printers and files. Utilize the Hyperterminal utility i...
Read More »
Source: http://www.ehow.com/how_6687449_program-cisco-router.html?ref=Tra...
User enable. router> enable router#
Read More »
Source: http://wiki.answers.com/Q/What_prompt_can_you_issue_show_commands...
http://www.cisco.com/en/US/ts/fn/100/fn15229.html
Read More »
Source: http://wiki.answers.com/Q/What_is_the_IOS_command_to_change_MTU_f...
R1# show cdp neighbors Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater Device ID Local Intrfce Holdtme Capability Platform Port ID R2 Eth 0/1 176 R S I 3640 Eth 0/2 R3 Fas...
Read More »
Source: http://wiki.answers.com/Q/How_to_use_a_cisco_router_command_view_...
show ip route
Read More »
Source: http://wiki.answers.com/Q/What_is_the_command_on_a_Cisco_router_t...
