Topic: Concrete Slab Design Guidelines
Not finding your answer? Try searching the web for Concrete Slab Design Guidelines
Answers to Common Questions
How to Design a Concrete Elevated Slab
Making an elevated concrete slab for your garden or driveway will take some hard work and time. First, however, you will need to know where to put it and how you want it to look. This step is important because it will help you estimate the ... Read More »
Source: http://www.ehow.com/how_6869177_design-concrete-elevated-slab.htm...
How to Design a Concrete Slab on Grade
A foundation is an extremely critical part of the building; it is the first part to be built, and everything that comes afterward depends on it. Foundations come in many types, and each one has its strengths and weaknesses. Concrete slabs o... Read More »
Source: http://www.ehow.com/how_5935449_design-concrete-slab-grade.html?r...
How do you design a reinforced concrete slab?
Engineers will consider the forces involved on the concrete slab and come up with a figure of -ve and +ve rebar needed to resist the moments. They will also consider the strength of concrete required, 20mpa, 32 mpa etc. Sometimes temperatur... Read More »
Source: http://wiki.answers.com/Q/How_do_you_design_a_reinforced_concrete...
More Common Questions
Answers to Other Common Questions
Sorry, i can't understand these but if you want send me the drawings of this slab and the elevation and i will try to help.
Read More »
Source: http://answers.yahoo.com/question/index?qid=20061104233424AA7zhgR
i do small jobs of concrete as a side job. nothing large such as whole houses. as far as what my materials would cost me here in missouri, it might be different in youre area just the concrete mix for a 4x12 foot slab would be about $120. t...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080423010202AAzG8YE
You're right, 760 psf is not much load, considering presumptive bearing pressures for spread footings on compacted soil, to say nothing of concrete, are 1,000-1,500 psf for most jurisdictions. A 5-inch floor slab is not really very robust,...
Read More »
Source: http://en.allexperts.com/q/Construction-Contractors-1093/2009/6/C...
additive material and composition make it cheaper and stronger
Read More »
Source: http://answers.yahoo.com/question/index?qid=20060803214603AA2BOK9
The manufacturer supplies a complete anchor bolt design with the building dimensions and reactions (or KIPS). From this information an engineer (hired by the customer) can design the proper foundation (required to receive local permits).
Read More »
Source: http://www.rhinobldg.com/faq/
Typically, you will need a foundation applicable to your climate zone. You need four inches of gravel base, six-mil plastic sheeting on top of the gravel, and then four inches of 2,500 to 3,000 psi concrete. Some jurisdictions require perim...
Read More »
Source: http://www.toolbase.org/toolbaseresources/level4FAQ.aspx?ContentD...
Advice and information on how to construct aconcrete floor slab should be visible below the timber joists (eg acases the possibility that you have a water leak, above. And up to% lighter than traditional solid concrete slab done by david we...
Read More »
Source: http://gov.mosepi.co.cc/athud.html
