Topic: Damped Oscillation
Not finding your answer? Try searching the web for Damped Oscillation
Answers to Common Questions
What is damped oscillation?
Oscillations (vibrations) are damped when they are changed by some action. For example, touching an oscillating (vibrating) tuning fork with your finger is said to be damping it. The oscillation (number of Hertz) of an electrical oscillator... Read More »
Source: http://wiki.answers.com/Q/What_is_damped_oscillation
How does surface area affect damping of an oscillation?
The larger the surface area, the larger the damping of an oscillation Read More »
Source: http://wiki.answers.com/Q/How_does_surface_area_affect_damping_of...
What is the time constant for the damping of the oscillation?
time constant TC = -(t1-t2)/ln(y1/y2) = 7.61153 s y(4.3) = y1*e^(4.3/7.61153) = 3.6946E-02 m Read More »
Source: http://answers.yahoo.com/question/index?qid=20100503142858AAIdtph
Featured Content:
Damped Oscillation
More Common Questions
Answers to Other Common Questions
You must be logged on to view this page!!
Read More »
Source: http://answers.yahoo.com/question/index?qid=20111121135323AAaAZpS
add a function like f(x) = e^-x That will force the y to zero when x-> +inf Source(s): see : http://www.wolframalpha.com/input/?i=f%2…
Read More »
Source: http://answers.yahoo.com/question/index?qid=20110919163811AA5m34B
Lenz's law: Induced current is always antiparallel to the motion that's causing it. As a copper disk goes through a magnetic field in one direction, the magnetic field induces a current on the disc which is in such a direction as to create ...
Read More »
Source: http://wiki.answers.com/Q/Why_the_oscillations_of_a_copper_disc_i...
If you are asking what causes the parasitic capacitance, look at the construction of the gate on the MOSFET. Two metal layers, separated by an oxide layer (dielectric). The definition of a capacitor. Also to get from one metal layer to anot...
Read More »
Source: http://uk.answers.yahoo.com/question/index?qid=20081101154246AAeN...
Damping limits the max excursion of the system. In electronics, it's according to the ratio of the reactance of one of the 2 resonant components at resonance to the resistance of the circuit. This ratio is called "Q".
Read More »
Source: http://uk.answers.yahoo.com/question/index?qid=20090302025711AACc...
The advantage or the disadvantage depends on the place where u use it.... for eg.. dampers are being used in car suspensions to avoid the spring reaching its resonant state.... if dampers are not used there then the spring would vibrate lon...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080218041431AAqV3Pa
