Topic: Datsun B210
Not finding your answer? Try searching the web for Datsun B210
Answers to Common Questions
What is the Firing order for a 1978 datsun b210?
Nearly all inline four-cylinder engines fire in the order 1,3,4,2. Take a moment and think about how the crankshaft looks - cylinders 1&4 move in unison but have opposite firing (same with 2&3). Hope this helps. Read More »
Source: http://wiki.answers.com/Q/What_is_the_Firing_order_for_a_1978_dat...
What is the point gap for a 1975 Datsun B210?
The point gap is .018 - .021 in or .45 - .55 mm, my source is Clymer Datsun Shop Manual. Good Luck, Kurt Read More »
Source: http://wiki.answers.com/Q/What_is_the_point_gap_for_a_1975_Datsun...
What is good about a Datsun B210?
The Datsun B210 is good because it is a very reliable car that can be driven for many miles. Read More »
Source: http://www.chacha.com/question/what-is-good-about-a-datsun-b210
Featured Content:
Datsun B210
More Common Questions
Answers to Other Common Questions
Spend a few dollars, and I mean litterly a few, for 2 bucks you can buy a used Haynes, or Chiltons repair manual and it will break it all down for you. That is the best way. Mark Wichita KS
Read More »
Source: http://wiki.answers.com/Q/How_do_you_remove_a_1974_Datsun_B210_ha...
you don.t its a manual
Read More »
Source: http://wiki.answers.com/Q/Where_do_you_put_transmission_fluid_in_...
I was unable to find the price for a 1982 B210 Datsun, but a 1982 Datsun 280ZX Turbo cost $111,000.
Read More »
Source: http://www.chacha.com/question/how-much-does-a-1982-b210-datsun-r...
Seatbelts. That's it - there were no ABS or airbags on those cars (or any other from that era).
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070707184533AA6BbnD
Brake light on the dash comes for two reasons 1; E-brake is pulled, there is a switch at the E-brake handle, it could be lose 2; warning switch at ether the brake master cylinder or the "Brake Line Safety Valve" that is lose or bad (Small "...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20070906124758AAhFQIT
It is there but can be in two ways. The first way is they use resistor wire which has resistance built into the wire length. The second way is that near the coil there is a white block with two terminals on either end, which puts the resist...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090801183540AA885Dy
