Topic: Door Header
Not finding your answer? Try searching the web for Door Header
Answers to Common Questions
How to Build a Header for a Door
Door frames are built in two concentric rectangular arches. The outside rectangle is made from 2-by-4 lumber and is part of the wall. The inside rectangle, also known as the door jamb, is made from 1-by-6 lumber. The header is the horizonta... Read More »
Source: http://www.ehow.com/how_6347401_build-header-door.html?ref=Track2...
How to Put in a Header for a Door
A door's header is the structural element that carries the load of the wall and ceiling above the opening. The correct installation ensures these loads are adequately supported for the size and type of door to be installed. This procedure f... Read More »
Source: http://www.ehow.com/how_5944165_put-header-door.html
How to Frame a Door Header
Framing a door header in a load-bearing wall requires the installation of a solid header beam, but tackling the same task in an interior non-bearing wall is a relatively simple procedure that can be applied to a door opening of any size. Lo... Read More »
Source: http://www.ehow.com/how_6197297_frame-door-header.html?ref=Track2...
More Common Questions
Answers to Other Common Questions
Position and nail in place the king studs and two jack studs per side. (See illustration for rough door frame parts and positions.) The jack studs are typically the height of the rough door frame, 81 to 82-1/2 inches, depending on the frame...
Read More »
Source: http://www.ehow.com/how_5163666_install-door-header.html
Building a structural header for a garage door opening can be handled on the jobsite and will offer the same structural support as more expensive solid wood beams. The procedure for constructing a header for 6-inch exterior wall framing can...
Read More »
Source: http://www.ehow.com/how_5980594_build-garage-door-header.html?ref...
Fabricating door and window headers on-site for a framing project saves time by using readily available framing materials and saves money over the cost of using larger, more expensive beams that are typically sold in minimum lengths that of...
Read More »
Source: http://www.ehow.com/how_6683845_build-window-door-headers.html?re...
When building a house, there are several areas of that are considered load bearing. Placing extra support above open spots in the framing, such as windows and doors, is crucial to the structural integrity of the building. There are no cente...
Read More »
Source: http://www.ehow.com/how_5763863_make-header-patio-door.html
There are several style options for French door header and foot slide bolts, both surface-mounted and inset, as well as many finishes to complement various decors. Although the inset type is slightly more expensive and more complicated to i...
Read More »
Source: http://www.ehow.com/how_5981255_install-foot-bolts-french-doors.h...
Construction of openings for doors and windows may seem confusing, but knowing the right information takes the confusion out of the equation. When it is time to install the door in the opening in the wall, the width of the opening should be...
Read More »
Source: http://www.ehow.com/how_6968930_do-bulid-header-over-door_.html
Too many questions, What's above it, what's the "Snow load", what are the local requirements... Your best bet would be to talk to a truss manufacturer in your area and see what they recommend. They'll give you some good information, especia...
Read More »
Source: http://wiki.answers.com/Q/What_is_the_normal_header_size_for_a_16...
