Topic: Draft Inducer Wood Stove
Not finding your answer? Try searching the web for Draft Inducer Wood Stove
Answers to Common Questions
How to Make a Wood Stove Draft
It is often difficult to get a wood stove to draft properly when first lit. The problem is caused by the chimney and/or stovepipe being too cold to create air flow through the wood stove. Make sure that there are no blockages, such as a bir... Read More »
Source: http://www.ehow.com/how_5503052_make-wood-stove-draft.html
How to Build a Down Draft Wood Stove
Down draft stoves are widely used among campers because they generate a lot of heat from a small amount of fuel that they burn completely with little or no smoke. The flame on top produces a zone that incinerates fuel through pyrolysis, a b... Read More »
Source: http://www.ehow.com/how_12218659_build-down-draft-wood-stove.html
How DO you improve draft oN your wood burning stove?
A clean chimney, shortest possible stovepipe with fewest bends. Chimney should extend higher than anything close to it. Be sure dampers are open. You may need "make up" air- air going up the flue had to come from somewhere. You may need to ... Read More »
Source: http://wiki.answers.com/Q/How_DO_you_improve_draft_oN_your_wood_b...
More Common Questions
Answers to Other Common Questions
You install a large enough flue with enough height to produce TOO MUCH draft and then 'trim' that with a damper. If you don't know that much, you've got no business messing about with trying to install any kind of flue. Mistakes here start ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20120221141837AAwEad9
I have been trying to find an answer for you. I grew up with an old wood burning stove. That and a fireplace were the only source of heat for a long time for us. The damper in the pipe is mainly just a place for creosote to build up, which ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090122021714AAJ6Ezq
If you can Access the flue tube you can install a chimney balloon to plug it off. In weatherization work we install them in abandon fireplaces and stoves. http://www.chimneyballoon.us You probably just need 9" one if it is a standard 8" tub...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20091108175136AAz8Zb0
If you don't have a draft gauge, it's pretty hard to be accurate. But you can use a match, candle, or a lighter and hold it in front of the stove door to see how strong it is, and turn the damper from open to close to check the difference.
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090211124337AARuKGt
