Topic: Fel Pro
Not finding your answer? Try searching the web for Fel Pro
Answers to Common Questions
What to do? After replacing valve cover gasket with dry fel-pro g...
Your new gasket has tabs that make it easy to set in place; the tabs hold the position properly on the cylinder head. The gasket also has the rubber coating to establish a tight seal between the cylinder head and the the valve cover, even i... Read More »
Source: http://www.fixya.com/cars/t2068789-after_replacing_valve_cover_ga...
What direction does a fel pro head gasket go? writing side up or ...
the side that's infused with sealant goes up. Read More »
Source: http://answers.yahoo.com/question/index?qid=20071014051558AAwwuUR
What Thickness Fel-pro MLS gaskets?
That is the point....junkyard motor. Tune is a bit off everytime I take it to thee syno the crooks find some reason to not tune it and still take my $ so I want to run it and know that it is 100. Read More »
Source: http://forums.corral.net/forums/superchargers/1194305-what-thickn...
More Common Questions
Answers to Other Common Questions
I am not thinking about running any kind of power adder on this car. I was just curious about the Novi as I have not been around them, mostly Vortech and ATI's. My T-Bird has the bottles and the the 1006's on it so if I feel the need to put...
Read More »
Source: http://forums.corral.net/forums/5-0-5-8-engine-tech/775433-what-f...
figured it out, never mind....
Read More »
Source: http://www.yellowbullet.com/forum/showthread.php?t=280513
The first step was that my grandfather walked the factory floor and knew every employee by name. He was communicating daily with everyone, which is easier to do when you are small. But, the philosophy continued. In 1947, we set up Fel-Progr...
Read More »
Source: http://www.winningworkplaces.org/aboutus/ourstory.php
