Topic: Gas in Crankcase
Not finding your answer? Try searching the web for Gas in Crankcase
Answers to Common Questions
How does gas get into the crankcase?
It would help to know the year, make and engine. Read More »
Source: http://wiki.answers.com/Q/How_does_gas_get_into_the_crankcase
How do you fix gas leaking into the crankcase?
chop it up with an axe then use duct-tape Read More »
Source: http://wiki.answers.com/Q/How_do_you_fix_gas_leaking_into_the_cra...
Why would a Briggs and Stratton motor dump large amounts of gas i...
Because the carburetor on these motors are no good after a few years. The carburetor will spew large amounts of gas into the crankcase and you do need to change the oil about 3 times after this happens to protect your engine and get all the... Read More »
Source: http://wiki.answers.com/Q/Why_would_a_Briggs_and_Stratton_motor_d...
More Common Questions
Answers to Other Common Questions
The fuel in the combustion chamber is not burning completely and seeping down the cylinder wall(s) into the crankcase. The spark plugs may be fouled or possibly one (or more) is not firing. You might also want to check for a clogged air fil...
Read More »
Source: http://wiki.answers.com/Q/What_could_cause_gas_to_get_in_the_cran...
Answer It's running too rich, getting too much fuel into the cylinder. BTW, that's very hard on the rings and cylinder, the gasoline is washing down the oil and causing a lot of extra wear. You probably have a leaky needle/seat in the carbu...
Read More »
Source: http://wiki.answers.com/Q/Why_does_gas_get_into_crankcase_of_port...
Usually this is from the needle valve in the carburetor being stuck open. If you're comfortable taking apart and working on the carburetor, read this for details on what to do, otherwise take the mower to a repair shop. Good luck! Please ra...
Read More »
Source: http://www.fixya.com/support/t5240009-gas_getting_into_oil_crankc...
you are getting to much fuel past your needle and seat.
Read More »
Source: http://wiki.answers.com/Q/Why_does_the_crankcase_on_Briggs_engine...
One or more of your cylinders are not holding their seal. Worn out piston rings, worn/damaged piston, worn/damaged cylinder wall are the most likely problem areas.
Read More »
Source: http://wiki.answers.com/Q/How_would_I_be_getting_gas_in_the_crank...
i would say your problem is blown piston rings instead of the gas combusting on top of the piston it is seeping through the piston rings and going down into your oil
Read More »
Source: http://www.answerbag.com/q_view/612030
float is stuck tap the carb with some thing. that may stop it. if not you will have to have the carb looked at by a pro
Read More »
Source: http://answers.yahoo.com/question/index?qid=20081224134858AAniBqY
