Topic: Gear Puller
Not finding your answer? Try searching the web for Gear Puller
Answers to Common Questions
What is a gear puller?
it is a mechanical 'claw' like device that is placed over each end of a metal gear with a center pin. as the center pin is wrenched inward the two 'claw' like arms are drawn away from the shaft this removing the gear from the shaft............ Read More »
Source: http://wiki.answers.com/Q/What_is_a_gear_puller
How to Use a Gear Puller to Pull Pulleys
You need to use a gear puller to pull a pulley off a motor when it will not slide off by hand. The gear puller uses three arms with jaws on the end of each one to grip the pulley from the back. You tighten a single screw in the center with ... Read More »
Source: http://www.ehow.com/how_12008077_use-gear-puller-pull-pulleys.htm...
Where can I find a Crankshaft Gear Puller?
any tools or auto store Read More »
Source: http://wiki.answers.com/Q/Where_can_I_find_a_Crankshaft_Gear_Pull...
More Common Questions
Answers to Other Common Questions
The first thing to do is remove the snap ring on the end of the crankshaft. The puller is made up of a half moon steel plate that slips between the block and the gear, a heavy steel bar that has bolts threaded through each end and that scre...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_get_the_crankshaft_off_using...
The lowest priced one that I found went for $35.00, so you're looking at spending a...
Read More »
Source: http://www.chacha.com/question/how-much-would-a-gear-puller-cost
Gear pullers are made in various shapes and sizes and have many uses. Always use the correct tool for the job. Wear safety glasses or goggles, or a faceshield. Select the proper gear puller for each job. Always use a gear puller of the requ...
Read More »
Source: http://www.ccohs.ca/oshanswers/safety_haz/hand_tools/gearpullers....
It can be removed but it requires a "pitman arm puller". Some auto parts stores will rent it to you.
Read More »
Source: http://wiki.answers.com/Q/How_can_the_pitman_arm_be_detached_from...
A gear puller is nothing more than a form of simple lever. What makes it a gear puller is the shape of the components. It is a screw jack where an inclined plane raises a lever. The other end of the lever is in the shape of a claw to grip t...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090427231009AAOmE9u
You shoud not need to pull off the timing gear at end of crankshaft. Rather, look for some type of "tensioner" that is holding timing chain (or belt) on so tight. Loosen it instead. Note: even with it loose, it will still be difficult to ge...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20060916162459AAGv5bJ
Usually you will have to remove the camshaft. This is a faily big job since you have to slide the cam out of the engine through where the radiator and grille usually are. So, start by disconnecting the neg. battery cable and the above two i...
Read More »
Source: http://wiki.answers.com/Q/300_ford_cam_timing_gear_has_spun_cam_n...
