Topic: Glass Fiber Reinforced Concrete
Not finding your answer? Try searching the web for Glass Fiber Reinforced Concrete
Answers to Common Questions
How to Stain Fiber Reinforced Concrete
Fiber reinforced concrete is typically used at locations where the flooring is continuously put under tremendous pressure. The fiber reinforcement allows the concrete to expand and stretch slightly without breaking under pressure. Staining ... Read More »
Source: http://www.ehow.com/how_6648210_stain-fiber-reinforced-concrete.h...
How to Finish Fiber-Reinforced Concrete Slab
Sometimes traditional concrete is not sufficient to handle the anticipated stresses on a concrete surface. Strengthening glass fibers added to the traditional components of cement, sand and gravel, make fiber-reinforced concrete the go-to c... Read More »
Source: http://www.ehow.com/how_7895384_finish-fiberreinforced-concrete-s...
What is hybrid fiber reinforced concrete?
The concrete in which more than one fiber types are used as secondary reinforcement is called hybrid fiber reinforced concrete. Read More »
Source: http://wiki.answers.com/Q/What_is_hybrid_fiber_reinforced_concret...
Featured Content:
Glass Fiber Reinforced Concrete
More Common Questions
Answers to Other Common Questions
Here is a site that will help you answer many questions concerning concrete technology. On the left column you'll see a link for Concrete Technology, when you go there you'll see FAQs on the left. Good Luck, ;-) http://www.cement.org/index....
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080203073450AANOzPw
the fiber is similar to that of hairy strands of fiberglass that serves as a secondary reinforcement. it is not intended to replace rebar or other structural reinforcement steel. it is primarily used to help control surface shrinkage cracks...
Read More »
Source: http://answers.yahoo.com/question/index?qid=1006021110912
The main disadvantage of carbon (Graphite) fibers is catastrophic mode of failure (carbon fibers are brittle).
Read More »
Source: http://wiki.answers.com/Q/Appearance_of_carbon_fiber_reinforced_p...
Glass fibres do not rust like steel reinforment can and they meld togeter like fiber glass dose, they (if mixed properly, for at least 10 mins beforehand) are more consistent throughout the mix too. Allow one bag of XT fibres (cost about £6...
Read More »
Source: http://wiki.answers.com/Q/What_is_the_difference_between_glass_fi...
When I was doing new builds in Michigan it was used all the time for interior basement flooring. As far as for interior decoration, my guess is that since the fibers do come to the surface, it would be a bit unsightly for design work GL
Read More »
Source: http://answers.yahoo.com/question/index?qid=20110921131547AAaW4lQ
Fiberglass Insulation, R Value of 3.14. Pine board has an R Value of 1.74
Read More »
Source: http://wiki.answers.com/Q/Which_material_has_the_highest_r_value_...
