Topic: Glock Barrels
Not finding your answer? Try searching the web for Glock Barrels
Answers to Common Questions
How to Put a Nonported Barrel in a Glock 19C
Glock manufactures its C-model pistols with two slots cut into the top of the barrel and the upper receiver. The purpose of the slots is to divert gases upward when the weapon is fired, which pushes the pistol downward to compensate for rec... Read More »
Source: http://www.ehow.com/how_7320473_put-nonported-barrel-glock-19c.ht...
How do I Make a Glock Short Barrel Rifle?
A Glock handgun can be converted into a short barrel rifle by using the lower receiver -- the grip assembly housing the trigger and magazine -- with a rifle kit available from Mech Tech Systems. The Glock lower receiver must be from a full-... Read More »
Source: http://www.ehow.com/how_6919080_do-glock-short-barrel-rifle_.html...
What is the barrel length of a Glock 21 pistol?
@ 125mm Read More »
Source: http://wiki.answers.com/Q/What_is_the_barrel_length_of_a_Glock_21...
More Common Questions
Answers to Other Common Questions
200-400 USD depending on condition, accessories, box, manual, etc..
Read More »
Source: http://wiki.answers.com/Q/What_is_the_value_of_a_used_Glock_40_sh...
Hi! The 'BARSTO' company is reviewed very highly. Check the link below for more details.
Read More »
Source: http://www.chacha.com/question/who-makes-the-most-accurate-replac...
The diameter is roughly 5/8ths of an inch. That was with an architects rule, not a caliper. Square that and multiply by Pi and you'll get the circumference of the outside of the barrel. The .40 S&W measures .400 in diameter. That would be p...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20110829102729AABNhgj
500-700 USD. Add 200 if you pay for the transfer tax stamp.
Read More »
Source: http://wiki.answers.com/Q/What_is_the_value_of_a_glock_40_cal_22C...
the barrel on your glock tips up after the bullet is out of the barrel and the spent case is extracted from the chamber. that is when this comes into play it adds in the feed of the next round! it does not affect the bullets trajectory that...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20090406213155AAzBe5k
I, also, think that a G-17 or a G-34 barrel would fit; but, 'Why' would you want to do that? If you're interested in achieving higher velocity, or adding porting, or some sort of muzzle attachment to the end of the barrel, then, you would b...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20100430151355AADuXuy
Well, the factory Glock barrel for your G-23 is as accurate as the shooter, but if you want to spend the money then listen to Pathfinder. H I see you don't allow e-mail so I'll just have to say this here (in response to your comment): If I ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080318041055AAirIGo
