Topic: Loosen Serpentine Belt Tensioner
Not finding your answer? Try searching the web for Loosen Serpentine Belt Tensioner
Answers to Common Questions
How to Loosen a Serpentine Belt Tensioner
So, you need to know how to loosen a serpentine belt tensioner. There are three types of tensioners that may be encountered when replacing a serpentine belt. Most domestic vehicles use a spring-loaded tensioner. This is a smooth pulley atta... Read More »
Source: http://www.life123.com/cars-vehicles/repair-troubleshooting/serpe...
How to Loosen a Serpentine Belt
Most engines are operated by a serpentine belt, which is a continuous belt that drives several devices simultaneously. Usually these are the alternator, the air conditioner, the water pump and the power steering pump. There are different co... Read More »
Source: http://www.ehow.com/how_7233728_loosen-serpentine-belt.html
How do you loosen tension on serpentine belt for 1998 F150?
Use a 1/2" socket wrench. From underneath the truck, put the 1/2" drive into the front of the tensioner pulley and rotate the tensioner in a downward direction to loosen the tension. If you want to remove the serpentine belt, slide the belt... Read More »
Source: http://wiki.answers.com/Q/How_do_you_loosen_tension_on_serpentine...
More Common Questions
Answers to Other Common Questions
I have used a socket with a ratchet handle. The ratchet will allow you to get more travel to move the pulley and get the belt off.
Read More »
Source: http://wiki.answers.com/Q/How_to_loosen_the_tensioner_to_replace_...
put a wrench on the nut that's holding the tensioner pully in place and PRY it one way or the other....it'll kind of swing one way or the other.. you'll have to hold against the spring tension hard enough that it gives you enough space to p...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_loosen_the_serpentine_belt_t...
Should be a square hole either 3/8" or 1/2" place a breaker bar in this hole and push or pull to relieve tension on belt tensioner to remove belt
Read More »
Source: http://wiki.answers.com/Q/How_do_you_loosen_the_tensioner_to_repl...
i belive u can use a helf inch wratcheck or breaker bar, look on the tensioner there should be a square whole, if not use a socke the fts the bolt on the tensioner pulley, it will only goe one way to relives the tension one which direction ...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_loosen_a_serpentine_belt_ten...
You will need a 1/2 " breaker bar / or a 1/2 " inch ratchet. Put in on the tensioner and pull towers you. This will release the tension. Repeat the procedure to put belt back on. Make sure you pay attention to how the belt goes on before re...
Read More »
Source: http://wiki.answers.com/Q/How_do_you_loosen_the_tensioner_to_repl...
Hello, i also have 97 mountianeer, when i changed my altenator i couldnt figure out where the tensioner was. but i looked at the belt routing diagram located under the hood by the headlights and the tensioner is on bottom of the motor on th...
Read More »
Source: http://wiki.answers.com/Q/How+do+you+replace+the+serpentine+belt+...
depends on whether you are talking about the inside belt (closest to the engine) or the outside belt (closest to the cooling fan). Outside belt - loosen the alternator bolt at the top (the one that slides in the curved groove on the bracket...
Read More »
Source: http://wiki.answers.com/Q/How+do+you+loosen+belt+92+crown+vic
