Topic: Maximum Load 8ohms Mean
Not finding your answer? Try searching the web for Maximum Load 8ohms Mean
Answers to Common Questions
How to Wire Speakers for an 8-Ohm Load
Get full sound from your speakers by wiring them together. Use this guide to wire a series of speakers together for an 8-ohm load. The best way to do this is to use a combination of series and parallel wiring. Read More »
Source: http://www.ehow.com/how_2036409_speakers-8ohm-load.html
What is maximum current given to 8 ohm speaker?
is not current or voltage but rather the product that is of concern Read More »
Source: http://wiki.answers.com/Q/What_is_maximum_current_given_to_8_ohm_...
What is the ratio of primary to secondary turns of a transformer ...
600 by 208 Read More »
Source: http://wiki.answers.com/Q/What_is_the_ratio_of_primary_to_seconda...
More Common Questions
Answers to Other Common Questions
in parallel No. Two 8 ohm 'speakers in parallel present a 4 ohm load.
Read More »
Source: http://wiki.answers.com/Q/How_do_you_wire_two_8_ohm_speakers_and_...
Wire two in parallel, wire two more in parallel, then hook the two parallel sets in series.
Read More »
Source: http://wiki.answers.com/Q/How_do_you_wire_four_eight_ohm_speakers...
If you paralel them 2.66ohm's if you seires them you will get 24ohm's keep flouding that BASS!
Read More »
Source: http://www.answerbag.com/q_view/981851
The ohm rating doesn't affect sound, just how much power is required. Lower ohms = higher power requirements.
Read More »
Source: http://www.chacha.com/question/what-is-better-a-1-ohm-load%2C-2oh...
http://www.the12volt.com/caraudio/woofer… Source(s): http://www.the12volt.com/
Read More »
Source: http://answers.yahoo.com/question/index?qid=20111008173619AAhjRWJ
Other than using just one of the voice coils, there isn't any way to wire a single DVC 4 ohm sub so that it presents a 4 ohm load. It can only be wired to 2 ohms (voice coils in parallel) or 8 ohms (voice coils in series). If the amp isn't ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20100529124432AA7B2eo
If the subs are 4 ohms each then heres what you do. Wire them in series....... Heres how..... Take the positive wire from the amp and hook it to the positive speaker terminal on the first speaker...... Then take a wire and connect it to the...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080329140903AAfQDvh
