Topic: No Water in Toilet Tank
Not finding your answer? Try searching the web for No Water in Toilet Tank
Answers to Common Questions
How to Conserve Water in a Toilet Tank
Are you worried about wasting too much water when you flush your toilet? The toilet-flushing mechanism is triggered by the water level in the tank. Putting a brick in the bottom of the toilet tank can make the water level rise while using l... Read More »
Source: http://www.ehow.com/how_4587745_conserve-water-toilet-tank.html
How to Replace the Water Tank on a Toilet
Clear out a space to work before you try to replace the water tank. You will probably end up on your knees reaching around behind the toilet so you need room to work. You will also need a place to sit the water tank down once you remove it ... Read More »
Source: http://www.ehow.com/how_5707118_replace-water-tank-toilet.html
How to Change a Flapper in That Money Eating, Water Wasting, Nois...
Locate the water cutoff valve underneath the tank. This valve will extend from the wall and is almost always silver in color. Remember, rightey tightey, lefty loosey. Turn the handle to the right and shut off the water. Flush the toilet. Th... Read More »
Source: http://www.ehow.com/how_5889460_change-wasting_-noisy-toilet-tank...
More Common Questions
Answers to Other Common Questions
If you have a septic tank then that is where the toilet water goes. If not you are probably part of the city sewage. In that case the toilet water goes to a treatment plant.
Read More »
Source: http://answers.ask.com/Home/Other/where_does_toilet_water_go
there is many different toilet tanks that use different fill valves but the concept is the same EXCEPT for pressure assist or (mostly in commercial buildings) flush valves which do not have toilet tanks. When water flows into the tank threw...
Read More »
Source: http://wiki.answers.com/Q/How_does_a_toilet_tank_fill_up_with_wat...
I would suspect the float valve assembly is defective. Replace this assembly with a modern assembly. Can be purchased at any hardware store.It also could be your flush gate not closing all the way either a plastic cone or a rubber flapper, ...
Read More »
Source: http://wiki.answers.com/Q/Why_does_the_toilet_tank_not_fill_up_wi...
You most likely have a problem either with the tank's gasket system (water keeps leaking back to bowl) or else the shutoff valves are faulty (poor water transport). You could also have trash either in your shut off valve or in your fill val...
Read More »
Source: http://wiki.answers.com/Q/Why_would_a_toilet_tank_not_refill_if_t...
Replace the flush valve or there is something buggered in the stop. Try opening the handle from the stop some more, if this doesn't help, you need to replace the flush valve in the tank.
Read More »
Source: http://wiki.answers.com/Q/Why_does_the_water_run_in_slowly_to_the...
The flapper in the bottom of the tank needs to be replaced or the chain going to it is too short.
Read More »
Source: http://wiki.answers.com/Q/Why_the_toilet_tank_water_keeps_emptyin...
If the fill valve in the tank is the type that has a round float that rides up and down on a post, they have a quarter size washer in them that can become stiff or get plugged. Some of these are in the base and the whole stack comes out, so...
Read More »
Source: http://wiki.answers.com/Q/Why_doesn't_water_come_in_to_the_toilet...
