Topic: Rough in Measurement for Toilets
Not finding your answer? Try searching the web for Rough in Measurement for Toilets
Answers to Common Questions
How to Rough Measure for the Plumbing of Toilets
If you are building a new bathroom, or planning a new home, you're responsible for the installation of the toilet plumbing fixtures, including the drain and water lines. Drains usually install right in the bathroom floor, so you only have t... Read More »
Source: http://www.ehow.com/how_10064384_rough-measure-plumbing-toilets.h...
What is aToilet rough in measurement?
Answer there are lots of different size toilets. Read More »
Source: http://wiki.answers.com/Q/What_is_aToilet_rough_in_measurement
How to Measure for a 10 Inch or 12 Inch Rough in for a Toilet
Installing toilets in new construction requires precise measurements so the drain pipe lines up with the toilet's trap. The drain pipe is installed long before the toilet, using the rough-in measurement that matches the rough-in dimension f... Read More »
Source: http://www.ehow.com/how_5808805_measure-12-inch-rough-toilet.html
More Common Questions
Answers to Other Common Questions
18" off sidewall and 12" off backwall. 18" and 12" are the center measurements for toilet rough-in. These are standard rough-in measurements.
Read More »
Source: http://wiki.answers.com/Q/How_do_you_measure_for_rough_in_toilet
A plumber "roughs-in" a toilet by installing the waste and vent lines as well as the water supply lines -- in short, everything but the toilet itself. The waste line begins at the toilet flange, which holds the toilet to the floor, and ties...
Read More »
Source: http://www.ehow.com/how_12190201_plumb-rough-toilets.html
Designing the plumbing installation for a toilet is called the rough in. This process is basically just the beginning of the process, where the installer figures out where the drain and flange go. It's dictated by the size of the toilet and...
Read More »
Source: http://www.ehow.com/how_12153519_rough-plumbing-toilet.html
The distance from the rearmost bowl hold-down bolts to the finished wall behind the toilet is called the toilet's rough-in. It refers to both the area where the waste outlet hole was placed to sit beneath the toilet as well as the toilet ro...
Read More »
Source: http://www.ehow.com/how_6749918_rough_in-toilets.html
Answer Depends on the toilet being purchased, but generally 12 inches from the wall to the center of the toilet flange for a residential toilet.
Read More »
Source: http://wiki.answers.com/Q/What_is_the_roughing_in_measurements_co...
Roughing in a toilet pipe is exactly what the name suggests -- it is the basic plumbing needed for a toilet, but is not finished and ready for use. It consists of a flange and drain that is attached to the drain pipe for the house and stick...
Read More »
Source: http://www.ehow.com/how_12200942_move-toilet-roughin.html
A rough-in is a flooring area that has been prepared with the necessary plumbing needed before installing a toilet. With the rough-in ready, installing a toilet can be done by a novice. You can install the toilet bowl and tank and get water...
Read More »
Source: http://www.ehow.com/how_12203502_install-roughin-toilet.html
