Topic: Routing Door Hinge Mortises
Not finding your answer? Try searching the web for Routing Door Hinge Mortises
Answers to Common Questions
How to Mortise a Door Hinge
A mortise is the carved-out area on a door where the hinge leaf is placed to lie flush with the surface of the door. For professional use, or if you're building a home and have many doors to hinge, two expensive tools called a router and hi... Read More »
Source: http://www.ehow.com/how_5002622_mortise-door-hinge.html
How to Install Mortise Hinges on a Door
When installing a wooden door into a door jamb, ideally the portion of the edge of the door and jamb should be mortised. The amount of material that will be replaced by the hinge should be removed from both the jamb and the edge of the door... Read More »
Source: http://www.ehow.com/how_7693964_install-mortise-hinges-door.html
How to Cut a Mortise Hinge on a Door
The key to hanging a door lies in mounting the hinges correctly. The hinge positions on the door and the doorjamb must both be mortised so that the hinge lies perfectly square along the door edge, and is also recessed flush with the surface... Read More »
Source: http://www.ehow.com/how_6711342_cut-mortise-hinge-door.html?ref=T...
More Common Questions
Answers to Other Common Questions
A recessed mortise allows a hinge to be installed flush with the edge of the door. This allows the door to close without leaving a gap at the hinge side. Cutting a recessed mortise requires patience and a couple of specialized tools but, wi...
Read More »
Source: http://www.ehow.com/how_12058259_cut-recessed-mortise-door-hinge....
When installing interior doors, you may have to mortise the doors to accept the hinges. Although some replacement doors come with a pre-made mortise, most solid wood door blanks do not. The mortise enables the hinge leaf to sit flush with t...
Read More »
Source: http://www.ehow.com/how_5901157_mortise-hinges-standard-interior-...
The door hinges for a wooden door need to be recessed into both the edge of the door and the door jamb. If the hinges are not recessed into a mortise, the gap on the hinge side of the door will be larger than necessary. While the mortise ca...
Read More »
Source: http://www.ehow.com/how_7702019_route-door-hinges.html
IF the door is a replacement, use the old door as a pattern as to where the hinges go. Draw hinge on door, use a SHARP chisle and hammer, mortise and set. Takes about one hour using this method. Not hard, just a pain.
Read More »
Source: http://answers.yahoo.com/question/index?qid=1006042828727
