Topic: Shackle Lifts
Not finding your answer? Try searching the web for Shackle Lifts
Answers to Common Questions
How to Do a Shackle Lift
With respect to a vehicle, a shackle is the arm bar that connects the leaf springs to the body of the vehicle. The longer the shackle, the greater the separation between the body of the vehicle and the frame. A shackle lift is a means of ad... Read More »
Source: http://www.ehow.com/how_8711799_do-shackle-lift.html
How to Build a Shackle Lift
Building shackle lifts is an effective way to gain better control of your sport utility or four-wheel drive vehicle. Shackles are rectangular-shaped pieces of metal that are used to increase the distance between the frame of the vehicle and... Read More »
Source: http://www.ehow.com/how_12141978_build-shackle-lift.html
How to Install Lift Shackles on a Jeep Wrangler
Installing lift shackles on a Jeep Wrangler will increase the suspension height but may stress the springs and cause them to sag prematurely. If you seek a little extra height on your Jeep, or you wish to level the rear to the front, lift s... Read More »
Source: http://www.ehow.com/how_7488282_install-lift-shackles-jeep-wrangl...
More Common Questions
Answers to Other Common Questions
Any suspension lift increases the distance from the axles to the frame. Shackles will only increase ride height half of their increased length over your originals because you are only moving one side of your leaf so for a two inch lift you ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20100516142039AA5d1De
You need two jacks and jack stands (for safety while you are working under the truck)--one jack to lift the truck frame and the other to lift the axle to take the load off of the spring. Do only one side at a time. Comments: Sep 27, 2009 - ...
Read More »
Source: http://www.fixya.com/support/t3029936-remove_old_shackles_install...
You need two jacks and jack stands (for safety while you are working under the truck)--one jack to lift the truck frame and the other to lift the axle to take the load off of the spring. Do only one side at a time.
Read More »
Source: http://www.fixya.com/cars/t3029936-remove_old_shackles_install_ne...
you could A: buy a highlift jack, itll be handy for future maintainance and for offroading B: use the standard scissor jack between the axle and the chassis rail the latter may well be dangerous id think . id loosen all the bo...
Read More »
Source: http://www.suzuki4x4club.com/forums/viewtopic.php?t=9128
it will give you 1.5" lift
Read More »
Source: http://www.naxja.org/forum/showthread.php?t=998692
If you plan on making your own, go with at LEAST 1/4" mild steel. I would highly recomend a bolt in support brace (or weld in) to keep them from bending over though. If you can, use 3/16" for the side plates. I made mine out of 1/4" with a ...
Read More »
Source: http://forums.off-road.com/jeep-short-wheelbase/77120-how-do-you-...
D-27 can break. So can a D-44. So can a D60. a D-44 is stronger than a D-27. By adding large tires you increase the chances that the shaft/ring/pinion will not survive long. By adding more height above the axle you increase the potential fo...
Read More »
Source: http://www.justih.org/Binder-Bench/showthread.php?t=12505
