Topic: Speaker Crossover Circuit Design
Not finding your answer? Try searching the web for Speaker Crossover Circuit Design
Answers to Common Questions
How to Design Speaker Crossovers
An axiom of great hi-fi is that speaker drivers should always be smaller than the wavelengths of sounds they are reproducing. For that reason, there are drivers of different sizes in a speaker to cover the entire audible realm. The goal of ... Read More »
Source: http://www.ehow.com/how_6325693_design-speaker-crossovers.html
How to Design a Multi-Speaker Circuit
Designing a multi-speaker circuit uses the same rules as a multi-resistor circuit. Multi-speaker circuits can be series circuits, parallel circuits or combination series-parallel circuits. Depending on the configuration used, the total impe... Read More »
Source: http://www.ehow.com/how_6791836_design-multi_speaker-circuit.html
How to design circuit diagram of hypersonic speaker?
Hypersonic speakers are usually "powered speakers" which means they have the amplifier built in. Any audio device with a "line level" output will work with these speakers. As long as the radio has a line level output, you should be OK. http... Read More »
Source: http://answers.yahoo.com/question/index?qid=20080717110904AArGnZg
More Common Questions
Answers to Other Common Questions
"maximum transfer of power is when load impedance equals output impedance." While that is true, it is totally irrelevant to audio amplifiers. An audio amplifier is a voltage source, the source impedance of which is in the tens of milliohms ...
Read More »
Source: http://answers.yahoo.com/question/index?qid=20080822160956AAQArpH
We recommend DSSF3 Realtime Analyzer for this purpose. Real time measurement by the octave band analyzer, power spectrum, and phase meter, or the distortion measurement by the THD analyzer will help adjustment of speaker. The problems in d...
Read More »
Source: http://www.ymec.com/products/qa2/index.htm
You should collect the frequency response numbers for each of the 4 elements, to figure out where you need to divide the frequencies. Then go to where @johnpowell suggested.
Read More »
Source: http://www.fluther.com/98855/how-do-i-design-the-passive-crossove...
